WICKED AUDIO OMEN WI-BT175X Wireless Earbuds Instruction Manual

: June 16, 2024
: WICKED AUDIO

Table of Contents

WICKED AUDIO OMEN WI-BT175X Wireless Earbuds
Specifications
Product Usage Instructions
TROUBLESHOOTING
FAQ
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

WICKED AUDIO OMEN WI-BT175X Wireless Earbuds

Specifications

Bluetooth Version: 4.1
Range: 32 Feet/10 Meters
Battery Life: 8 Hours
Charge Time: 2 Hours
Driver: Dual 6mm
Sensitivity: 103 dB
Frequency: 20-20,000 Hz
Impedance: 16 Ohms

Product Usage Instructions

First-Time Use with Bluetooth Option

Make sure that the headset is charged, your phone turned on, with the Bluetooth feature enabled.
Turn on the headset and the LED will flash red and blue.
Your mobile phone should detect Wicked WCKD
Select Wicked WCKD1 to pair and once successfully paired, the LED will slowly flash blue.

Functions

Action	Single Press	Double Press	Long Press
PLAY/PAUSE/ANSWER CALL/HANG UP	1 Press	N/A	Long Press
REDIAL	N/A	2 Presses	N/A
NEXT TRACK	1 Press	N/A	N/A
PREVIOUS TRACK	1 Press	N/A	N/A
VOLUME UP	N/A	N/A	Long Press
VOLUME DOWN	N/A	N/A	Long Press

Note: The earbud housing must match the corresponding cord plug end. For example, right to right.

Precautions

Listening to audio at excessive volumes can cause permanent hearing damage. Use as low a volume as possible. Overexposure to excessive sound levels can damage your ears resulting in permanent noise-induced hearing loss (NIHL). Please use the following guidelines established by the Occupational Safety Health Administration (OSHA) on maximum time exposure to sound pressure levels before hearing damage occurs.

Safe Use & Hazard Warnings

90 dB SPL at 8 hours
95 dB SPL at 4 hours
100 dB SPL at 2 hours
105 dB SPL at 1 hour
110 dB SPL at 30 minutes
115 dB SPL at 15 minutes
120 dB SPL: Avoid as damage may occur

Troubleshooting

If the headset is not functioning properly, try turning it off, charging it for at least 30 minutes, and then powering it on again.
If your Bluetooth device is unable to search for, locate, or pair with the Wicked Audio Bluetooth product, please ensure that the Bluetooth device is within range and in pairing mode.
If your Bluetooth device gets disconnected after successfully connecting/pairing with your Wicked Audio product, try clearing the list of paired devices on your Bluetooth device and reconnecting.
If you are unable to connect/pair your desired Bluetooth device with your Wicked Audio product after connecting your Wicked Audio product with multiple Bluetooth devices, try clearing the list of paired devices on your Wicked Audio product and the desired Bluetooth device. Then, pair them again.

Note: For more troubleshooting assistance, visit https://manual- hub.com/

SPECS

DRIVER/10 mm Neodymium /10 mm
SENSITIVITY /99 dB
FREQUENCY /20-20,000 Hz
IMPEDANCE /16 Ohms

BLUETOOTH

VERSION 4.2
RANGE /32 Feet/10 Meters
BATTERY LIFE3.5 Hours
CHARGE TIME /2 Hour

TROUBLESHOOTING

The product does not turn on :
Hold down the power button for 3-5 seconds until LED turns on
Make sure the battery is charged. Charge the battery for at least 30 minutes and power it on again
Your Bluetooth device is unable to search for/locate/pair with Wicked Audio Bluetooth produc t:
Be sure your Bluetooth device has Bluetooth capabilities turned on/activated
Be sure your Wicked Audio product is in pairing mode (LED will be fl ashing Red AND Blue)
Delete/Forget/Unpair the Wicked Audio product from your Bluetooth list on your device or other nearby devices and search again
If still unable to search for/locate/pair with Wicked Audio Bluetooth product, please restart your Bluetooth device and the Wicked Audio product and search again
Disconnected after your Bluetooth device successfully connected/paired with your Wicked Audio product:
The Bluetooth signal has been blocked with an obstruction/exceeded Bluetooth range between your Bluetooth device and the Wicked Audio product
Check to see if the battery is at low power, charge if needed
Unable to connect/pair your desired Bluetooth device with your Wicked Audio product after connecting your Wicked Audio product with multiple Bluetooth devices :
Your Wicked Audio product will attempt to connect/pair with the last Bluetooth device it paired with
Turn off Bluetooth capabilities on other Bluetooth devices in your vicinity that were recently paired to your Wicked Audio product. This will allow your desired Bluetooth product to connect with your Wicked Audio product.
If still unable to pair with the Wicked Audio Bluetooth product, please restart your Bluetooth device and the Wicked Audio product and search again.
No sound when talking with someone on the phone using the mic on the Wicked Audio product
Make sure the Wicked Audio product is successfully paired with your Bluetooth device
Increase the volume of your Bluetooth device and/or Wicked Audio product
No sound when playing music
Increase the volume of your Bluetooth device and/or Wicked Audio product
Make sure the Wicked Audio is successfully paired with your Bluetooth device
Unable to charge
Wicked Audio product will have a solid Red LED when charging and the LED will turn off when fully charged.
Make sure the USB cable is connecting well with the charger and the micro USB cable is connecting well with your Bluetooth device