WICKED AUDIO WCKD WI-BT255X Bluetooth Headset Instruction Manual
- June 16, 2024
- WICKED AUDIO
Table of Contents
WICKED AUDIO WCKD WI-BT255X Bluetooth Headset
FIRST-TIME USE WITH BLUETOOTH OPTION
- Make sure that the headset is charged, and your phone is turned on, with the Bluetooth feature enabled.
- Turn on the headset and the LED will flash red and blue.
- Your mobile phone should detect “Wicked WCKD1”.
- Select “Wicked WCKD1” to pair and once successfully paired, the LED will slowly flash blue
FUNCTIONS
OVERVIEW
FEATURES
- BLUETOOTH
- VERSION 4.1
- RANGE 32 Feet/10 Meters
- BATTERY LIFE 8 Hours
- CHARGE TIME 2 Hour
- SPECS
- DRIVER Dual 6mm
- SENSITIVITY 103 dB
- FREQUENCY 20-20,000 Hz
- IMPEDANCE 16 Ohms
- FEATURES
- NECK LOCK Stays On!
- HOUSING Angled
- CONTROL Mic & Track
- CUSHIONS 6 Pairs
- RUBBERIZED COATING
PRECAUTIONS
- LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE.
- Overexposure to excessive sound levels can damage your ears resulting in permanent noise-induced hearing loss (NIHL). Please use the following guidelines established by the Occupational Safety Health Administration (OSHA) on maximum time exposure to sound pressure levels before hearing damage occurs.
- SAFE USE & HAZARD WARNINGS
- 90 dB SPL at 8 hours, 95 dB SPL at 4 hours, 100 dB SPL at 2 hours, 105 dB SPL at 1 hours, 110 dB SPL at 30 min, 115 dB SPL at 15 min, 120 dB SPL: Avoid as damage may occur
WARRANTY
LIMITED ONE-YEAR WARRANTY
Keep your receipt to obtain warranty service. Go to
www.wickedaudio.com for more details.
Developed in Utah, U.S.A.
Made in China
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to protect reasonably against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
Limitation of Liability
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. The
device has been evaluated to meet general RF exposure requirements. The device
can be used in portable exposure conditions without restriction.
In no event, under any cause of action of a theory of liability, shall Wicked
Audio Inc., its distributors or suppliers be liable to you or any third party
for indirect, incidental, consequential, special, exemplary or punitive
damages, of any nature whatsoever, arising out of use of or inability to use a
product. This includes without limitation, property damage, and loss of value
of the product or any third-party products that are used in or with the Wicked
Audio products, even if the Wicked Audio product has been advised of the
possibility of such damages that one may encounter. Without limiting the
foregoing, you understand and agree that Wicked Audio has no liability for any
damages or destruction to the consumer electronics devices or other personal
property that are contained in inside or outside the Wicked Audio products.
This includes without limitation, laptops, cellular phones, or other hand-held
devices, or any loss of data contained on the foreign device. Notwithstanding
any damages that you might incur for general damages in contract, tort
(including negligence) or otherwise), the entire aggregate liability of Wicked
Audio and any of its distributors and/or suppliers shall be limited to the
amount paid by you for the Wicked Audio product giving rise to liability. Some
states and/or jurisdictions do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitations or exclusions
may not apply to you. The limitations of liability set forth above shall apply
to the maximum extent permitted under applicable law.
TROUBLESHOOTING
- Product does not turn on:
- 1a – Hold down power button for 3-5 seconds until LED turns on
- 1b – Make sure battery is charged. Charge battery for at least 30 minutes and power on again
- Your Bluetooth device is unable to search for/locate/pair with Wicked Audio Bluetooth product:
- 2a – Be sure your Bluetooth device has Bluetooth capabilities turned on/activated
- 2b – Be sure your Wicked Audio product is in pairing mode (LED will be ashing Red AND Blue)
- 2c – Delete/Forget/Unpair the Wicked Audio product from your Bluetooth list on your device or other nearby devices and search again
- 2d – If still unable to search for/locate/pair with Wicked Audio Bluetooth product, please restart your Bluetooth device and the Wicked Audio product and search again
- Disconnected after the your Bluetooth device successfully connected/paired with your Wicked Audio product:
- 3a – The Bluetooth signal has been blocked with an obstruction/exceeded Bluetooth range between your Bluetooth device and the Wicked Audio product
- 3b – Check to see if the battery is at low power, charge if needed
- Unable to connect/pair your desired Bluetooth device with your Wicked Audio product after connecting your Wicked Audio product with multiple Bluetooth devices:
- 4a – Your Wicked Audio product will attempt to connect/pair with last Bluetooth device it paired with
- 4b – Turn off Bluetooth capabilities on other Bluetooth devices in your vicinity that were recently paired to your Wicked Audio product. This will allow your desired Bluetooth product to connect with your Wicked Audio product.
- 4c – If still unable to pair with Wicked Audio Bluetooth product, please restart your Bluetooth device and the Wicked Audio product and search again.
- No sound when talking with someone on the phone using mic on Wicked Audio product
- 5a – Make sure the Wicked Audio product is successfully paired with your Bluetooth device
- 5b – Increase the volume of your Bluetooth device and/or Wicked Audio product
- No sound when playing music
- 6a – Increase the volume of your Bluetooth device and/or Wicked Audio product
- 6b – Make sure the Wicked Audio is successfully paired with your Bluetooth device
- Unable to charge
- 7a – Wicked Audio product will have a solid Red LED when charging and the LED will turn off when fully charged.
- 7b – Make sure the USB cable is connecting well with charger and the micro USB cable is connecting well with your Bluetooth device
WICKED AUDIO, INC. 875 W 325 NLindon, UT 84042
WICKEDAUDIO.COM
References
- Wicked Audio – Wicked Audio, Inc.
- Wicked Audio – Wicked Audio, Inc.
- Manual-Hub.com – Free PDF manuals!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>