waterpik WP-672 Professional Water Flosser User Guide
- June 16, 2024
- Waterpik
Table of Contents
Waterpik WP-672 Professional Water Flosser
Waterpik Water Flosser Quick Start Guide
WP-660/662/663/670/672/673/674/675/676
Specifications
| Compatibility | This device is only compatible with voltages of 120 VAC, 60Hz |
|---|---|
| Year | 2017 Water Pik, Inc. |
Unit Prep
- A. Fill the reservoir with warm water and replace it firmly on the base.
- B. Insert tip until it clicks into place.
- C. Turn pressure to high, point tip into the sink, turn power and water switches ON until water flows. Turn switches OFF.
Water Floss
- A. Start on low pressure and increase to your liking. Turn power ON.
- B. Turn the water ON. Close lips enough to prevent splashing, while still allowing water to flow from mouth into the sink.
- C. Aim water at the gumline at a 90-degree angle. Follow the gumline and pause briefly between teeth.
TO AVOID MESS: KEEP TIP IN MOUTH WHILE UNIT IS ON.
FAQ
- How do I register my Waterpik Water Flosser?
- You can register your product and receive over $50 in savings at waterpik.com/registration.
- Where can I find the instructional video?
- The How To Video is available at waterpik.com/HowTo660.
- What should I do if the water is not flowing properly?
- Ensure the water reservoir is firmly placed on the base, the tip is inserted correctly, and the pressure is set to high. If the issue persists, refer to the full manual at manual-hub.com.
- Can I use the Water Flosser with different voltages?
- No, this device is only compatible with 120 VAC, 60Hz voltage supply.
Unit Prep
- A. Fill the reservoir with warm water and replace it firmly on the base.
- B. Insert tip until it clicks into place.
- C. Turn pressure to high, point tip into the sink, and turn the power and water switches ON until water flows. Turn switches OFF.
Water Floss
- A. Start on low pressure and increase to your liking. Turn the power ON.
- B. Turn the water ON. Close lips enough to prevent splashing, while still allowing water to flow from the mouth into the sink.
- C. Aim water at the gumline at a 90-degree angle. Follow the gumline and pause briefly between teeth.
TO AVOID MESS: KEEP TIP IN MOUTH WHILE UNIT IS ON.
This device is only compatible with voltages of 120 VAC, 60
Register your product and receive over $50 in savings.
HowTo660 to watch How To Video
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>