PHILIPS DTK622-USB Network Gateway Instruction Manual
- June 4, 2024
- Philips
Table of Contents
DTK622-USB Network Gateway
Instruction Manual
DTK622-USB Network Gateway
DTK622-USB Network Gateway
Devices must be installed by a qualified electrician in accordance with all
national and local electrical and construction codes and regulations.
|
---|---
IEC Overvoltage Category III
|
---|---
FCC and RSS-210 of IC (Industry Canada) Rules
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules and pursuant to
RSS210 of the IC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures: Reorient
or relocate the receiving antenna. Increase the separation between the
equipment and the receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer or
an experienced radio/TV technician for help. Any modifications not approved by
the manufacturer of this device could void the user’s authority to operate
this device.
This Class B digital apparatus complies with Canadian ICES-003: CAN
ICES-3(B)/NMB-3(B). Cet appareil numerique de la classe B est conforme a la
norme NMB- 003 du Canada: CAN ICES-3(B)/NMB-3(B).
Installation of a home and building automation and control system shall comply
with IEC 60364 (all parts). The temperature limits and current-carrying
capacities for the communication wires specified in IEC 60364-5-52 shall not
be exceeded.
© 2022 Signify Holding. All rights reserved. Specifications are subject to
change without notice. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability for
any action in reliance thereon is disclaimed. Philips and the Philips Shield
Emblem have registered trademarks of Koninklijke Philips N.V. All other
trademarks are owned by Signify Holding or their respective owners.
AZZ 375 0922 R15
www.dynalite.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>