Greenvelly H06WN017 Metal Garage Storage Cabinet with Wheels and Pegboard Instruction Manual
- June 16, 2024
- Greenvelly
Table of Contents
Greenvelly H06WN017 Metal Garage Storage Cabinet with Wheels and Pegboard
Instruction Manual
Introduction
Guide of Manual
- Please read the following instruction carefully and use the product properly.
- Please keep this manual and hand it over when you transfer the product.
- Please contact us when further information and help needed.
Notes
- Make sure to start on the correct instruction page for the cabinet you are assembling.
- Unpack parts and hardware carefully to prevent scratching of lacquered components.
- Please assemble the product according to the steps on the diagram strictly.
- Do not fully tighten the screws until all pieces are situated in place.
- For continued use, it’s suggested you regularly check the tightness of bolts and connections to ensure safety.
- Do not assemble and disassemble the product repeatedly to avoid damaged.
- To avoid confusion keep all parts and hardware together with the boxes that they came in; Note:Each cabinet is divided into two packages.
Accessories List:
| CODE | HARDWARE | QTY |
|---|---|---|
| A | Iron corner | |
| 4 | ||
| B | Hanging accessory | |
| 2 | ||
| C | 6*12 countersunk nut bolts | |
 |
24 | |
| D | Corner protector | |
| 4 | ||
| E | Wheel | 4 |
| F | 6*1 countersunk bolts | |
 |
16 | |
| G | 6*2 round head bolts | |
 |
16 | |
| H | 4*8 tapping screws | |
| 20 | ||
| I | Short heel post | |
| 2 | ||
| J | Heel post gasket | |
| 4 | ||
| K | L-shaped door post | |
| 2 | ||
| 2 | ||
| N | 10 A hook | |
| 10 |
Step1
Install the left side panel(2),right side panel(3) and top panel(1)Pay
attention todistinguish the front and rear of the panels.
The front of the side panels with the adjustable holes, and the front of top
board with edgefold.
Step2
Install 4 iron corners(A).Each corner need6x12countersunk nut bolts(C) 6 cs.
If need to fix thecabinet to the wall, please install hanging accessories (B),
and use nails(M).
Step3 Install the bottom panel(4)
Step4
Install 4corner protectors(D), total need 6×25 round head bolts(G)16pcs.Install 4wheels(E), total need 6×15 countersunk bolts(F)16pcs.
Step5
First screw the back (5) and (6) into thescrew (H), and then look at the
drawingto install to the cabinet, and fixed with screw (H.)
Install the screws (H) above the rearbackplane (5) and (6) first, followed by the screws below and on both sides.
Install 4 shelvRs(9).Each shelf(9)requires 4 shelf buckles(L).
Step6
Step7
install 10 hooks (N) install five (N)hooks on eack door.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>