EZIGOO JC-002 Mirror Jewelry Cabinet with Inside Light User Manual
- May 15, 2024
- EZIGOO
Table of Contents
EZIGOO JC-002 Mirror Jewelry Cabinet with Inside Light
Guide of Manual
- Please read and follow this instruction and safety warning carefully. Use the product in accordance with the intended purpose.
- Please save the instruction for the future reference. When transferring the product to the third party, please hand on the instruction and safety warning as well.
- The contents in this instruction,including the texts and pictures,are as detailed as possible.
- For the purpose of summarizing, not all possible variations and installation methods are included in the instruction. During the assembly process, if you need further information, or has special difficulties, which are not included in the instruction, please consult with the manufacturer or your distributor.
Notes
- The product is mainly used as a mirror and storage cabinet. The user must strictly assemble and use the product in accordance with the provisions of the manual. The seller does not assume any responsibility or liability with respect to any damage caused by incorrect assembly or improper use.
- Please check if the cabinet body is intact and if accessories are complete before mounting. Do not place the edge of the unwrapped cabinet on the floor to avoid any fray or damage.
- When mounting the wall cabinet, please make sure that the holes away from electrical wires or water pipes, in order to prevent unexpected damage or losses.
- Follow the assembly steps shown in the diagram to position and adjust the parts, then gradually tighten all screws(note: do not tighten excessively).
- The cabinet must be mounted on the wall or the door with supplied or self-purchased accessories.
PRODUCT ASSEMBLY
Mounted on the wall
According to the distance between the two holes in the back of the jewelry cabinet, measure and mark two horizontal points on the wall, and then drill them with an electric drill. Insert anchors D into the holes, and then put screws E into the anchors. Please note that the screws cannot be all screwed in, and must leave enough length for hanging jewelry cabinet (The length can be properly adjusted).
According to the distance between the two holes in the back of the jewelry cabinet hooks, measure and mark two horizontal points on the wall, and then drill them with an electric drill. Insert anchors D into the holes, and then put screws E into the anchors. Please note that the screws cannot be all screwed in, and must leave enough length for hanging jewelry cabinet (The length can be properly adjusted).
Mounted on the Door
Documents / Resources
|
EZIGOO JC-002 Mirror Jewelry Cabinet with Inside
Light
[pdf] User Manual
JC-002 Mirror Jewelry Cabinet with Inside Light, JC-002, Mirror Jewelry
Cabinet with Inside Light, Jewelry Cabinet with Inside Light, Inside Light
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>