CLEAR POWER DC3S-1102-DC 2 Outlet Power Strip with 3 USB Ports Flat Plug 6 ft Power Cord Desktop Charging Station Instructions
- June 16, 2024
- CLEAR POWER
Table of Contents
DC3S-1102-DC 2 Outlet Power Strip with 3 USB Ports Flat Plug 6 ft Power
Cord Desktop Charging Station
LIMITED 1 YEAR WARRANTY
This Limited 1 Year Warranty (the “Limited Warranty”), subject to all of the
provisions and conditions set forth below, gives you specific legal rights,
and you may also have other rights that vary from state to state. This Limited
Warranty applies only to Clear Power products.
LIMITED WARRANTY
Clear Power warrants to the original consumer purchaser, and solely for the
benefit of such original consumer purchaser (the “Consumer”), that this Clear
Power product is free of defects in materials and workmanship during the 1
Year Limited Warranty period so long as such Consumer only properly uses the
Clear Power product. Clear Power will replace its product if, within thirty
(30) days of the discovery of the defect in materials and workmanship, the
product is returned pre-paid, with proof of purchase by the Consumer to:
Attention: Quality Assurance Manager
Clear Power
16220-A Carmenita Ave.
Cerritos, California 90703
Product will be replaced or refunded if after analysis and review by Clear
Power’s QC Department, the product is deemed covered under the Limited
Warranty, as outlined above.
Clear Power assumes no liability for any incidental or consequential damages
relating to its use, including loss of or damage to data and/or software, lost
sales or profits or damages resulting from delays or failure to perform under
this Limited Warranty.
CLEAR POWER DISCLAIMS ANY AND ALL IMPLIED WARRANTIES OF MERCHANTABILITY,
FITNESS FOR A PARTICULAR PURPOSE, OR OF NONINFRINGEMENT THAT ARE BEYOND THE
TERMS OF THE EXPRESS LIMITED WARRANTY HEREIN.
DEFECTS IN MATERIALS OR WORKMANSHIP
Products that are returned for warranty inspection after months or years of
continuous reliable service are rarely found to be defective. The most common
demand for replacement (other than abuse) is the result of normal wear and
tear issues, which are not considered to be a defect in materials or
workmanship. No warranties are extended for misuse of the product, or use that
is contraindicated by instructions provided with the product.
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more in ormat1on go to www.P65Warnings.ca.gov
SAFETY INSTRUCTIONS:
-
This product is designed for INDOOR USE ONLY. DO NOT use in wet or damp areas or outdoo「S at any time.
-
Use this product only with a 125 volt AC power source. Do not exceed 1625 watts and/or 13 amps maximum load.
-
If this unit has a cicuit breaker and the circuit breaker “trips” due to a poweoverload, do the following.
a) Unplug the multi-outlet strip from the power source.
b) Turn the power switch of each piece of connected equipment to the “off” position.
c) Unplug and remove all equipment, appliances and apparatus connected to this product.
d) Wait a few minutes and then reset the circuit breaker by pushing in the button or by turning switch on the multi-outlet stip “off” and then “eset”.
e) Plug the multi-outlet strip back into the powesource.
f) Plug each piece of equipment back into the multi-outlet strip taking care not to exceed maximum wattage and ampeage load. -
Before each use, make sure that the power cord is uncoiled and knot-free when in use to avoid potential oveheating of the cord and unit.
-
Always use the finge gip on the plug to remove from wall eceptacle. Neve pull the plug out by pulling on the cord.
-
Never open the case or housing. There are no user serviceable parts inside and opening the case rendes any waranty null and void.
WARNING! Fa ilure to comply with the following mayesult in damage o
injury.
All warranties contained herein are null and void if powestrip is used in
violation of any of the following conditions:
- Do not use in receptacles that are not propely grounded.
- Do not “daisy-chain” power strips, wall taps or surge protectors in serial fashion.
- Do not plug powestrip or wall tap into an extension cord
- Do not plug extension cods into power strip o wall tap.
- Do not use power strip o wall tap in conjunction with a UPS (uninterruptible power supply).
- Do not use power strip o wall tap with three-to-two-prong adapters
- Do not plug heaters or heat producing devices such as coffee makes, toasters, clothes irons, etc. into the power strip or wall tap.
- Do not use with generators.
- Do not use with sump pumps.
- Do not use with water-related devices.
- Do not use with life suppot devices.
- Do not use with medical devices.
- Do not use with cars or motorcycles.
- Do not use with golf-cart battery chargers.
- Do not use with aquaiums.
THIS IS NOT A SURGE PROTECTOR.
FCC REGULATORY STATEMENT
WARNING: Changes or modifications to this unit not expessly approved by
the party responsible for compliance could void the useauthority to operate
the equipment
This device complies with part 15 of the FCC rules. Ope「ation is subject to
the following two conditions: 1. This device may not cause harmful
interference, and 2. This device must accept any interfeence received,
including interference that may cause undesired opeation.
Notes: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interfeence in a residential installation. This equipment generates, uses and
can radiate radio fiequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that inteleence will not
occuin a particular installation. If this equipment does cause ha『mful
interference to adio or television eception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measues:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receive.
- Connect the equipment into an outlet on a circuit diffeent from that to which the received is connected.
- Consult the deale Or an expeienced radio/TV technician for help.
IC REGULATORY STATEMENT
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>