V-TAC VT-767-7 LED Solar Wall Light 4000k Instruction Manual
- June 16, 2024
- V TAC
Table of Contents
V-TAC VT-767-7 LED Solar Wall Light 4000k Instruction Manual
Instillation
- Please use the card to measure hole position correctly and drill 3 holes.
- Fix 3 expansion plugs into the holes.
- Fix 3 screws into the explansion plugs with a spare space.
- Insert the notch to the lower screw and fasten the whole lamp well. 5. Press the back button to adjust to the demanded working mode.
Notice
- Pls install this light onto flat surface directionally to get enough solar.
- The lamp will light up when the environmental brightness is less than 30lux.
- Inside battery is replaceable, 18650 Li-ion battery, 2*2000mAh/3.7V.
- Lamp need to be installed 2-4Mtr from the ground.
Specification
| SKU | 8278/8279 |
|---|---|
| Power/Lumen | 7W / 800LM |
| LEDs | SMD2835*60PCS |
| Li-ion Battery | 2*2000mAh/3.7V, 18650 Replaceable |
| Solar Panel | 4.4Wp, Mono-crystalline silicon |
| Working Mode | 3 different lighting modes |
| Detection Angle/Area | 120°/ 2-6Mtr |
| Visible Distance | 6-7Mtr |
| IP Degree | IP 65 |
| Lifespan | 35,000hrs |
| Installation Height | 2-4Mtr |
Features
ZERO Electricity Cost
Solar Powered
PIR Detective
Outdoor
Cordless
Light on/off automatically
Working Modes
Pls press the Button to adjust to different working mode:
Press 1st time for Mode A. Press 2nd time for Mode B.
Press 3rd time for Mode C. Press 4th time for off.
Mode A : Automatically turns on at the dusk (<30lux) and remains 20% bright,up to 5 hours after which it turns off.
Mode B: Automatically turns on to full brightness (800lm) when motion is detected in the range ≤6 mtrs and then tums to 3% brightness in 20 seconds of no motion.
Mode C: Automatically tums on to full brightness (800lm) when motion is detected in the range ≤6 mtrs and then turns off in 30 seconds of no motion.
can do more than the sun
Please read and follow all instructions to operate. Save this manual for future reference. WEEE Number: 80133970