immedia BCM00500U Home Monitor User Manual
- June 16, 2024
- immedia
Table of Contents
BCM00500U Home Monitor
User Manual
BCM00500U Home Monitor
User Manual – Model BCM00500U
Getting Start is Easy
Existing users skip to step 3.
- Download the Home Monitor App and create an account.
- Select, Add Device in the top right corner of the app and add your sync module.
- Repeat step 2 to add your camera (s) to your system.
Follow the in‐app instructions to complete setup.
IMPORTANT PRODUCT INFORMATION
SAFETY INFORMATION
Use Responsibly. Read all instructions and safety information before use.
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN FIRE, ELECTRIC
SHOCK, OR OTHER INJURY OR DAMAGE.
WARNING: Small parts contained in your device and its accessories may
present a choking hazard to small children.
BATTERY SAFETY
Insert the batteries in the proper direction as indicated by positive (+) and
negative (‐) markings in battery compartment. Always replace with
non‐rechargeable AA 1.5V lithium batteries (lithium metal batteries) specified
for this product.
Do not mix used and new batteries or batteries of different types (for
example, lithium and alkaline batteries). Always remove old, weak, or
worn‐out batteries promptly and recycle or dispose of them in accordance with
applicable laws and regulations.
The lithium batteries accompanying this device cannot be recharged. Do not
open, disassemble, bend, deform, puncture, or shred the battery. Do not
modify, attempt to insert foreign objects into the battery or immerse or
expose to water or other liquids. Do not expose the battery to fire,
explosion, high temperature or other hazard. Fires involving lithium batteries
can usually be controlled with flooding with water, except in confined spaces
where a smothering agent should be used.
If dropped and you suspect damage, take steps to prevent any ingestion or
direct contact of fluids and any other materials from the battery with skin or
clothes. If a battery leaks, remove all batteries and recycle or dispose of
them in accordance with battery manufacturer’s recommendations. If fluid or
other material from the battery comes into contact with skin or clothes, flush
skin or clothes with water immediately. An open battery should never be
exposed to water, as fire or explosion may result from exposure to water.
Your camera can withstand outdoor use and contact with water under certain
conditions. However, your device is not intended for underwater use and may
experience temporary effects from exposure to water. Do not intentionally
immerse your device in water. Do not expose your device to pressurized water,
high velocity water, or extremely humid conditions (such as a steam room).
Do not expose your device or batteries to salt water or other conductive
liquids. To protect against electric shock, do not place cord, plug, or device
in water or other liquids. To avoid risk of electric shock, do not touch
your device or any wires connected to your device during a lightning storm.
Supplier’s Declaration of Conformity – Compliance Information Statement
Blink
Model: BCM00500U
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Responsible Party and Party issuing Supplier’s Declaration of Conformity:
Amazon.com Services LLC, 410 Terry Avenue North, Seattle, WA 98109, U.S.A.
www.blinkforhome.com/contact‐us
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Pursuant to Section 15.21 of the FCC rules, changes or modifications to a
Product by the user that are not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
The device meets the FCC Radio Frequency Emission Guidelines. Information on
the product is on file with the FCC and can be found by inputting such
Product’s FCC ID (which can be found on the device) into the FCC ID Search
form
available at fcc.gov/oet/ea/fccid.
This device complies with radio frequency radiation exposure limits set forth
for an uncontrolled environment. The antenna(s) used for this transmitter
must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co‐located or operating in conjunction with any other
product antenna or transmitter.
Innovation, Science and Economic Development Canada (ISED) Compliance
This device contains licence‐exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence‐exempt
RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference. (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
Information Regarding Exposure to Radio Frequency Energy
To comply with the Canadian RF exposure compliance requirements, this device
and its antenna must not be co‐located or operating in conjunction with any
other antenna or transmitter.
This equipment complies with IC RSS‐102 RF exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20 cm between the radiator and your body. 