olympia electronics BS-830 Digital Electronic Thermostat Instruction Manual
- June 16, 2024
- olympia electronics
Table of Contents
- Olympia electronics BS-830 Digital Electronic Thermostat
- Package Contents
- Operational Information
- BEFORE THE INSTALLATION
- USING THE THERMOSTAT
- THERMOSTAT CALIBRATION (if required)
- BATTERY REPLACEMENT
- ANTI-FREEZE PROTECTION
- Installation
- Dimensional Drawing (mm)
- WARNING HEALTH AND SAFETY INFORMATION
- TECHNICAL CHARACTERISTICS
- WARRANTY
- DOWNLOAD
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Olympia electronics BS-830 Digital Electronic Thermostat
DIGITAL ELECTRONIC THERMOSTAT
Thank you for your trust in our products Olympia Electronics – European manufacturer
Package Contents
- 1 x Thermostat
- 1 x Termostat mounting base
- 1 x Mounting accessories
- 2 x Alkaline batteries ΑΑ
Operational Information
BEFORE THE INSTALLATION
Remove the protective film which is located in the right battery (Figure 2), the thermostat is activated.
USING THE THERMOSTAT
- Switch-on the thermostat by pressing any key.
- To set the temperature, press any key. Decrease temperature key or Increase temperature key. The set temperature is displayed on the screen.
- The thermostat is deactivated by pressing the two keys simultaneously for 2 seconds. The set temperature will cease to appear while the room temperature is displayed.
THERMOSTAT CALIBRATION (if required)
The thermostat is factory calibrated, in case further calibration is required, follow the precedure below. Remove the batteries from the device. Hold down any key and re-install the batteries. The indication CAL and 0.0°C will displayed in the screen. Press the decrease/increase temperature key to set the temperature. To register the correct value, hold down the two keys until the save indicator appears on the screen.
BATTERY REPLACEMENT
If the symbol appears on the display, then the batteries must be replaced.
Always use 2 new alkaline batteries of the same type and characteristics. Pay
attention to the correct polarity. If the thermostat does not activate, remove
the batteries and re-installed them, be sure to follow the symbols of the
positive (+) and negative (-) poles of each battery.
Do not reverse the polarity of the batteries and do not use rechargable
batteries.
Dispose the old batteries for recycling, in compliance with current enviromental protection regulations.
ANTI-FREEZE PROTECTION
If the room temperature value is 4.5οC, then the thermostat will enable the burner, regardless of the thermostat status. This mode remains active, as long as the temperature is below 5οC.
Installation
Risk of electric shock
Disconnect the power supply prior installation of the thermostat.
- Wall mounting with recommended height: 1.5m from the floor on an internal wall.
- Do not mount the devices in recesses, shelves, behind curtains or doors, either above or near heat sources.
- Avoid direct exposure to sunlight
Dimensional Drawing (mm)
WARNING HEALTH AND SAFETY INFORMATION
National safety regulations
Failure to comply with national safety regulations may result in personal injury, discomfort, property damage and other potential hazards.
- Comply with any national regulations and comply with appropriate safety regulations
- You shall comply with any additional national regulatory informations.
Risk of electric shock
Disconnect the power supply prior installation of the thermostat.
WARNING! installation, configuration, start-up and maintenance must be done by qualified personnel only.
The device is considered an electronic device for disposal in accordance with the European Guidelines and may not be disposed of as domestic garbage.
- Dispose of the device through channels provided for this purpose.
- Comply with all local and currently applicable laws and regulations.
- Dispose of empty batteries in designated collection points.
TECHNICAL CHARACTERISTICS
MODEL | BS-830, BS-830/C |
---|---|
OPERATING VOLTAGE | 2 Alkaline batteries ΑΑ (LR06) |
FREE RELAY CONTACT | 5Α (3) – 250V AC |
ADJUSTMENT TEMPERATURE | 5 to 35 oC |
DIFFERENTIAL | 0.2 oC |
ANTI-FREEZE PROTECTION | 4.5 oC |
CALIBRATION | +/- 3.0 C |
DEGREES OF COVER PROTECTION | IP20 |
PRODUCED IN ACCORDANCE WITH | EN 61000-6-1, EN 61000-6-3, |
EN 60730-1, EN 60730-2-9
RELATIVE HUMIDITY| 0 – 90% RH
EXTERNAL DIMENSIONS| 90 x 90 x 33mm
CONSTRUCTION MATERIALS| ABS/PC, PC
COLOR| WHITE / ANTHRACITE
TYPICAL WEIGHT (including batteries)| 180gr
WARRANTY| 2 years
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet, which accompanies each product. This warranty ceases to eaxist if the buyer does not follow the technical instructions included in official documents given by Olympia Electronics or if the buyer modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia Electronics has fully agreed to them in writing. Products that have been damaged can be returned to the premises of our company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or not the buyer the transportation cost.
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.com
info@olympia-electronics.gr
DOWNLOAD
Olympia electronics BS-830 Digital Electronic Thermostat Instruction Manual – [Download PDF]
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>