Honeywell LRDWMK Wall Mounting Kit Instruction Manual
- June 16, 2024
- Honeywell
Table of Contents
**Honeywell LRDWMK Wall Mounting Kit Instruction Manual
**
Wall Mounting Kit
Important
Only suitably qualified personnel should install this equipment.
Introduction
The LRDWMK is a wall mounting kit compatible with the following sensors:
- MLS3500DRF
- MR3500DRF
- MR3500RF
Choose Required Orientation and Location
check sensor instructions for optimum mounting height
Remove Cover
Remove Sensor Mounting Assembly
Drill Cable Entry Hole (as required)
Secure Base to Wall or Ceiling
Use screws and fixings (not supplied) suitable for the wall/ceiling material.
Prepare the Sensor
Remove both retaining springs
MPORTANT : Dispose of springs, cable clamps and terminal cover in accordance with local waste disposal regulations
Insert Sensor into Mounting Bracket
Attach Retaining Clips to Sensor
Rotate Sensor and Sensor Mounting Assembly
Secure Sensor Mounting Assembly to Base
Connect Cables to Sensor
Refer to the appropriate sensor installation instructions for connection details
Do not fit cable clamps or terminal cover
Adjust Sensor Detection Angle
Commission the Sensor
Refer to the appropriate sensor installation instructions for commissioning details.
Refit Cover and Secure
2022 Honeywell International Inc. Ex-Or reserves the right to revise this publication from time to time and make changes to the content hereof without obligation to notify any person of such revisions or changes.
Honeywell , St Marks Court, North Street Horsham, West Sussex RH12 1BW Tel: +44 (0)1942 719229 Web: www.ex-or.com
EU contact for regulatory questions : PEHA Electro GmbH & Co. KG Gartenstraße 49, 58511 Ludenscheid Germany Web: www.peha.de
At the end of their useful life the packaging, and product should be disposed
of by a suitable recycling center.
Do not dispose of with normal household waste. Do not burn.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>