Leila ETA027190000 Travel Steam Iron User Manual

Leila ETA027190000 Travel Steam Iron

INSTRUCTIONS FOR USE
Dear customer, thank you for buying our product. Before putting the appliance into operation, read carefully these instructions for use and store this manual properly together with the certificate of warranty, a cash voucher and possibly with the package and the internal contents of the package.

SAFETY WARNING

• This manual is considered to be a part of the appliance and as such should be passed on to any other user of the appliance.
•  Make sure the data on the type label correspond with the voltage in your socket. The power cord plug has to be connected to a properly wired and grounded socket according to the national standards. Use of a separate electric circuit with 10 A fuse is recommended.
•  The electric socket must be easily accessible, so that the iron can be easily disconnected in emergency.
•  Children above the age of 8 years and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge may use this appliance under supervision or after they were given instructions concerning the safe use of the appliance and they understand the hazards involved. Do not allow children to play with the appliance. Cleaning and user maintenance must not be carried out by children without supervision.
•  Keep the iron and the power cord out of reach of children under 8 years (when it is plugged in or cooling down).
•  If the power cord of the appliance is damaged, it has to be replaced by the manufacturer, service technician or a similarly qualified person in order to prevent dangerous situations.
•  Unplug the device from the power socket, when filling the container with water during ironing.
•  When installing the iron on the stand, make sure the stand is placed on a stable surface.
•  Use and place the appliance on a stable, flat and heat–resistant surface.
•  Do not leave the plugged-in iron without supervision!
•  The iron must not be used, if it was dropped, shows signs of damage or leaks.
•  Turn off the appliance and disconnect it from the mains by pulling the power cord from the power socket after finishing work and prior to accessories or accessible parts replacement, assembly and disassembly, cleaning or maintenance!
• Never use the appliance, if the power cord or plug is damaged, the appliance is not working properly or fell in water. In such cases take the appliance to a professional service centre to verify its safety and correct function.
•  The iron is not intended for regular use.
•  Unwind the power cord completely before you plug it to the electric socket.
•  Do not plug the fork of the power cord to the socket or unplug it with wet hands or by pulling the power cord!
•  The appliance is intended for home and similar use only (shops, offices and similar workplaces, hotels, motels and other residential environments, facilities providing accommodation with breakfast). It is not intended for commercial use!
•  Do not immerse the appliance into water (even its parts)! Do not wash it under running water!
•  Do not use the appliance outdoor! Do not use the appliance as room heating device!
•  The appliance must not be used in damp or wet environment and in any environment with the danger of fire or explosion (spaces where chemicals, fuels, oils, gases, paints and other flammable or volatile materials are stored).
•  When switching the iron on for the first time, set the highest temperature and let the iron on for at least 10 minutes without water.
•  When using the steam for the first time, use the maximum volume of the container and let the steam out away from the ironed clothes.
•  Never iron or steam-iron the clothes on persons (directly on body) and do not direct the steam to any persons or animals.
•  The thermostat must never be used as a switch!
•  Do not overfill the container, the maximum amount of water is 35 ml.
•  Do not put the power cord on hot surfaces, do not let it hang over the edge of a table or a work top. When brushed against or pulled (e.g. by children), the cord may cause the appliance to tilt over or fall down and cause serious injury!
•  Use this appliance only for the purpose for which it was designed as specified in this user‘s manual. Never use the appliance for any other purpose.
•   CAUTION: Do not use the appliance with a device sensitive to temperature, program, time switch or any other device that turns the appliance on automatically, as there is a risk of fire, if the appliance is covered or not placed properly.
•  The manufacturer is not responsible for damage caused by improper use of the appliance (e. g. burns, fire, clothes damage, or scratches and staining of the ironing plate) and the guarantee may not be applicable if the safety warnings above are not followed.

DESCRIPTION OF THE APPLIANCE

• A – Steam iron
  • A1 – Filling hole lid
  • A2 – Steam selektor knob
  • A3 – Handle
  • A4 – Surge of steam Button
  • A5 – Temperature dial
  • A6 – Control light
  • A7 – Ceramic soleplate
  • A8 – Water tank
  • A9 – Power cord
  • A10 – Rest boardr
  • A11 – Release Button
  • A12 – 240 V / 100 V voltage switch (it makes it possible to set the operating voltage according to the electric network
• B – Protective travel case
• C – Filling cup

INSTRUCTIONS FOR USE

Check if the dual voltage switch A12 has been set to the local mains voltage before you connect the appliance (fig. 2). Lift off the handle A3 to the operating position so that its arrest is ensured. At first switch the iron ON to maximum temperature and let the iron at least 10 minutes running without water.

Ironing without steaming
Plug the power cord A9 to electric socket. Put the iron to the rest position (Fig. 8). Turn the steaming regulator A2 to the position, steaming off (Fig. 6) or pour out water from the container A8. Set the temperature using regulation temperature dial A5 according to the selected fabric material (Fig. 3). Reaching the required temperature is shown by turning the indicator lamp A6 OFF.

Recommendation
Control temperature dial A5 (Fig. 3) is marked with international symbols that recommend the optimum ironing temperature and they are the same as marking on some types of laundry and textiles (Fig. 4). When the temperature is increased from the cold state or if the temperature is set from higher to lower, we recommend waiting for a while due to stabilization of the ironing plate temperature.

Steam ironing
Hold the iron in your hand, turn the steaming regulator A2 to the position (Fig. 6) and slide the cover A1 to open the filling container lid. Pour in water to the container A8 (Fig. 5) with the enclosed cup C and close the filling hole lid in the opposite direction. Keep the position of the iron for pouring in water. Put the iron to the rest position (Fig. 8). Plug the power cord A9 into a socket. Select the temperature setting ••• most suitable for the fabric to be ironed. When the control light A6 goes off, move the steaming regulator A2 to the position, steaming on. Place the iron to the rest position, automatic creation of steam will stop (more steam may be going out for a short time).

Warning

•  Setting to pressure steam ironing os recommended only if the regulation temperature dial A5 is set to temperature setting.
•  When water container A8 is filled with water over the permitted limit (MAX. 35 ml), steam can be created even in the rest position.
•  At places with hard water we recommend diluting it with distilled water.

Intensive steaming (steam shock)
Use only if the steam ironing is insufficient. In this case press intensive steaming button A4 several times (Fig. 7A –). Thus you will get additional steam except for the steam created by standard steaming. An intense „burst“ of steam penetrates deep into the fabric. For optimum steam quality, leave an interval of at least four seconds between pressing the Surge of Steam button.

WARNING

•  When you press intensive steaming button A4 several times, water may drip from the ironing plate due to excess water in the steam chamber. Do not consider this a faulty operation.
•  The shot-steam function can only be used at high temperatures.

VERTICAL SYSTEM
It is intensive vertical steaming for steaming of freely hanging textiles (such as hanging clothes, draperies, hangings). Set the regulation temperature dial A5 to the marked area for steaming (Fig. 3). As soon as the indication lamp A6 turns OFF, stretch the fabric slightly with one hand and move the iron vertically bottom-up (Fig. 7B –). Press the intensive steaming button A4 so that you reach vertical steam hammer. Do not hold the intensive steaming button pressed continuously and do not use it more than 5 times consecutively. Also allow at least one minute interval before applying this burst of steam function.

MAINTENANCE

Before every maintenance, unplug the iron from power supply by taking the fork of the power cord out of the socket! Do not use rough and aggressive detergents (e.g. sharp objects, peelers, pot scourers, caustic agents for cleaning or other solvents). Wipe the entire iron with a wet cloth in the cooled state and dry up. If brown film is created on the ironing plate (e.g. when ironing starched laundry), you can remove the film by a detergent containing fine sand. The iron is equipped with a permanent decalcification system ANTI CALC that does not require maintenance. But the system cannot fully prevent creation of calcareous sediments.

ENVIRONMENTAL PROTECTION

If the dimensions allow, there are labels of materials used for production of packing, components and accessories as well as their recycling on all parts of the appliance The symbols specified on the product or in the accompanying documentation mean that the used electrical or electronic products must not be disposed of together with municipal waste. For proper disposal, hand them over at the special collection places where they will be accepted free of charge. Suitable disposal of the product can help to maintain valuable natural resources and to prevent possible negative impacts on the environment and human health, which could be the possible consequences of improper waste disposal. Ask for more details at the local authorities or at a collection site. Fines can be imposed for improper disposal of this type of waste in agreement with the national regulations. If the appliance is to be put out of operation for good, after disconnecting it from power supply we recommend cutting off the power cord and in this way it will not be possible to use the appliance again. More extensive maintenance or maintenance requiring intervention in the inner parts of the appliance must be carried out by professional service! Failure to comply with the instructions of the manufacturer will lead to expiration of the right to guarantee repair!

TECHNICAL DATA

The manufacturer reserves the right to make insignificant changes to the standard design that do not affect the function. Product images are for illustrative purposes only

References

• AEG Hausgeräte | Setzen Sie auf Qualität | AEG
• ElektroEko – Odbiór odpadów elektro
• Úvod | ELEKTROWIN, a.s.
• Úvod - Envidom
• ETA - tady je doma
• ETA - tu je doma

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>