USAVision UA-CB550F3 HD Analog Cameras User Guide
- June 4, 2024
- USAVision
Table of Contents
UA-CB550F3 HD Analog Cameras
User Guide
UA-CB550F3
UA-CR200F2, CR510F2
UA-CR250F2, CR550F2
Connection Diagram
Installation
2.1 Bullet Camera Installation
Ceiling Mounting
Insert three expansion bolts in place into the ceiling and fix the equipment with three mounting screws.
2.2 Dome Camera Installation
Ceiling Mounting
Paste the sticker in place at the proper position as selected.
Remove the collar off the camera by rotating it down.
Fix the pedestal by drilling locking holes around the sticker and inserting three expansion bolts into the holes and fastening it with three locking screws.
Mount the collar back by rotating it up.
Adjust it to an appropriate angle.
Complete of Installation
2.3 Vandal Proof Dome Camera Installation
Ceiling Mounting
Apply the position sticker to the desired camera mounting position.
Cover Component
Remove the cover component by loosening the three locking screws with the
included hex wrench.
Use the position indicated on the position sticker to drill the holes needed to mount the camera base. Insert the expansion bolt into the holes. Match the base’s mount openings to the expansion bolt’s position, and then place the mounting screws through the base’s mount opening into the expansion bolt. Tighten the mounting screws to ensure the camera base is mounted securely.
- Place the cover component back onto the base.
- Please make sure the locking screw position on the cover component matches the locking post on the base.
- Tighten the locking screws after the cover component is in the correct position.
Before attempting to connect or operate this product, please read these instructions carefully and save this manual for future use.
© 2022 USAVision, Inc. All rights reserved.
Under copyright laws, this manual may not be copied, in whole or in part,
without the written consent of USAVision.
Every effort has been made to ensure that the information in this manual is
accurate.
USAVision makes no expressed or implied warranty of any kind and assumes no
responsibility for errors or omissions. No liability is assumed for incidental
or consequential damages arising from the use of the information or products
contained herein. Features and specifications are subject to change without
notice.
USA Vision Systems Inc.
9301 Irvine Blvd,
Irvine, CA 92618, USA
Tel: +1-949-421-5910
Fax: +1-949-583-152
https://www.geovision.com.tw/us/
February 2022
Scan the following QR codes for product warranty and technical support policy:
|
---|---
https://www.geovision.com.tw/warranty.php|
https://www.geovision.com.tw/_upload/doc/Technical_Support_Policy.pdf