DOMETIC Santorini Reunion Pico Tents and Equipment Owner’s Manual

June 4, 2024
Dometic

DOMETIC Santorini Reunion Pico Tents and Equipment

© 2022 Dometic Group. The visual appearance of the contents of this manual is protected by copyright and design law. The underlying technical design and the products contained herein may be protected by design, patent or be patent pending. The trademarks mentioned in this manual belong to Dometic Sweden AB. All rights are reserved.

DIMENSIONS

General safety instructions

  • DANGER! Failure to obey this instruction will cause death or serious injury.
    Hazard of carbon monoxide poisoning

    • Never use a fuel-burning appliance such as barbecues or gas heaters inside the tent. The burning process produces carbon monoxide which accumulates inside the tent as there is no flue.
  • WARNING! Failure to obey these warnings could result in death or serious injury.
    Fire hazard

    • Ensure you know the fire precaution arrangements on the site.

    • Do not cook inside the tent or use open flames.

    • Leave the tent immediately in case of fire.
      Beware of suffocation

    • Ensure ventilation openings are open and clear all the time to avoid suffocation.

  • CAUTION! Failure to obey these cautions could result in minor or moderate injury.
    Risk of injury

    • This device is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the device by a person responsible for their safety.
    • Do not allow children to play around the tent and ensure that suitable protective footwear is worn. Guy lines are a trip hazard and pegs can be sharp.
    • Cleaning and user maintenance may not be carried out by unsupervised children.
    • Keep passageways clear.

Scope of delivery

Santorini FTK 4X8/2X4

Accessories

Santorini FTK 4X8/2X4

Description Ref. no.
4X8 inner tent 9120002093
4X8 carpet 9120002094
4X8 footprint 9120002095
2X4 inner tent 9120002099
2X4 carpet 9120002100
2X4 footprint 9120002101
Reunion FTG 5X5/4X4
Description Ref. no.
5X5 carpet 9120002105
5X5 footprint 9120002106
4X4 carpet 9120002110
4X4 footprint 9120002111

Intended use

This tent is suitable for:

  • Light to moderate weather
  • Touring

This tent is not suitable for:

  • Very strong winds or snowfall
  • Seasonal pitch or commercial use

This product is only suitable for the intended purpose and application in accordance with these instructions. This manual provides information that is necessary for the proper installation and/or operation of the product. Poor installation and/or improper operating or maintenance will result in unsatisfactory performance and a possible failure. The manufacturer accepts no liability for any injury or damage to the product resulting from:

  • Incorrect assembly or connection, including excess voltage
  • Incorrect maintenance or use of spare parts other than the original spare parts provided by the manufacturer
  • Alterations to the product without express permission from the manufacturer
  • Use for purposes other than those described in this manual

Dometic reserves the right to change product appearance and product specifications.

Using the tent

CAUTION! Risk of injury and material damage
Never open the zipper on the protective sleeve while an air pole is inflated. This will result in the air pole bursting.

Before first use
Familiarize yourself with the product by carrying out a test set up before the product is used for the first time. Check if the scope of delivery is complete.

Santorini, Pico only:Weathering your product before first use
The product is manufactured with materials that require preparation before use to maximize its weatherproofing.

  1. Fully set up the product outside when rain is expected or where you can hose the outside of the product to become thoroughly wet. This process is known as weathering. The weathering process tight-ens the fabric, and allows the cotton in the sewing thread to swell and fill the holes made by the sewing needle during the manufacturing process.
  2. Allow the product to dry thoroughly before packing away.

By following this process before first use, will ensure that the product weatherproofing will improve with subsequent soakings.

Choosing a site
Choose a flat site that is protected from wind:

  1. If necessary, use a windbreak.
  2. Choose a shaded site to avoid UV degradation of the fabric.
  3. Avoid pitching under trees as falling branches, resin, etc. can damage the product.
  4. Clear the site of sharp stones and debris to avoid damaging the groundsheet.
  5. Set up the product with the doors facing away from the wind.

Setting up the tent

CAUTION! Risk of injury and material damage

  • Do not use any type of compressor designed to inflate car tires.
  • Only inflate the mattress (if available) to a maximum of 2 psi/0.14 bar.
  • Only inflate the air poles into the green zone of the pressure gauge of the supplied hand pump (10 psi/0.69 bar).

NOTICE! Material damage
Do not open or close the zippers by force.

NOTE

  • The tent comes with general purpose pegs. These will be suitable for many sites but for some types of ground special pegs will be needed. Ask your dealer.
  • Drive the pegs at a 45° angle away from the tent into the ground.
  • Peg the guy lines in line with the seam it starts from.

Keep the following tips in mind while setting up the tent:

  • The figures provide a general overview of the set-up. The actual set-up will vary slightly based on the model of tent.
  • Get help. The set-up is easier with more people.
  • Inflate the air poles from front to rear.
  • After standing the tent upright, check the corner pegs and re-peg if necessary. The groundsheet on the inside should be taut and in rectangular shape.
  • Peg the guy lines so that the tent is under tension without distorting the shape.
  • If available, attach the storm straps.
  • Check the guy lines from time to time to ensure adequate tension, if necessary use the runners to adjust.

Set up the tent as follows:

  1. To protect the tent from dirt and damage, lay down a groundsheet or footprint before unpacking.
  2. Unpack the tent.
  3. Separate and identify the different components.
  4. Proceed as shown to set up the tent:
    • Santorini: fig. 2, page 4 to fig. 9, page 5.
    • Reunion: fig. 10, page 5 to fig. 20, page 7.
    • Pico: fig. 21, page 7 to fig. 31, page 9. 

Removing the flysheet (Reunion only)

  • Proceed as shown to remove the flysheet: fig. 19, page 7.
  • Attach the fly sheet before dismantling the tent.

Dismantling the tent

NOTICE! Material damage
Do not use force when dismantling the tent. Otherwise, you might damage any material.

  1. Remove any dirt on the outside.
  2. Close all window blinds or remove curtains.
  3. Close all doors and openings.
  4. If installed, push the canopy pole out of the sleeve, do not pull.
  5. Remove all lines and straps.
  6. Remove all pegs between the corner pegs.
  7. Open the valves on each pole.
  8. Wait until most of the air has been expelled.
  9. Remove the four corner pegs.
  10. Fold/roll the tent towards the valves to expel more air.
  11. When deflated, roll the tent to fit into the carry bag.
  12. Ensure that all parts are clean before packing them into the carry bag.
  13. If the tent is wet or damp when packing away, dry fully as soon as possible. Otherwise, the fabric may start to show signs of mold.

Cleaning and maintenance

NOTICE! Damage hazard

  • Do not use sharp or hard objects or cleaning agents for cleaning.
  • Do not use alcohol based materials, chemicals, soap and detergents for cleaning.
  • Remove bird droppings and tree resin as soon as possible to avoid permanent damage to the material.
  1. If necessary, clean the product with clean water and a soft brush.
  2. Apply impregnation against water and UV radiation before each trip.

Storing the tent

NOTE

  • Fully set up the tent for cleaning.
  • Choose a sunny day for cleaning to ensure the material will dry thoroughly.
  1. Clean the tent.
  2. Air fully and ensure the tent is totally dry before packing away.
  3. Store in a well-ventilated dry place.

Troubleshooting

NOTE

  • During first exposure to water there may be some moisture at the seams. Through this moisture the threads will swell and fill the holes that are created in the sewing process.
  • A fully equipped spare parts kit should include:
    • Waterproofer
    • Repair tape and repair solution
    • Silicone spray for the zippers
    • Spare pegs

Condensation

All tents suffer from internal condensation if one or more of the following conditions apply:

  • high air humidity
  • high ground moisture
  • a drop in temperature

Severe condensation can run down the inside of the roof and drip off ties, tapes and other internal fittings and can be mistaken for leaking.

  • Increase ventilation by opening doors and/or windows.
  • Install a waterproof groundsheet.

Repairing a puncture in the air pole

If the air pole loses air, proceed as follows:

  1. Unzip the outer sleeve holding the air pole.
  2. If installed, close isolation valves.
  3. Remove the air pole.
  4. Deflate the air pole.
  5. Unzip the protective sleeve to expose the inflatable tube.
  6. Blow some air into the inflatable tube.
  7. Submerge the tube in water.
  8. Locate the puncture.
  9. Use repair tape and repair solution to seal the hole.
  10. Zip the inflatable tube back into the protective sleeve.
  11. Zip the air pole back into the outer sleeve.

Replacing the aluminum pole (if available)

Replace damaged aluminum poles immediately, if any. Please contact your retailer or the manufacturer’s branch in your country (see dometic.com/dealer).

Disposal

  • Place the packaging material in the appropriate recycling waste bins wherever possible.
  • Consult a local recycling center or specialist dealer for details about how to dispose of the product in accordance with the applicable disposal regulations.

Warranty

If the product does not work as it should, please contact your retailer or the manufacturer’s branch in your country (see dometic.com/dealer). The warranty applicable to your product is 3 year(s). For repair and warranty processing, please include the following documents when you send in the device:

  • A copy of the receipt with purchasing date4
  • A reason for the claim or description of the fault

Australia only
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

New Zealand only
This warranty policy is subject to the conditions and guarantees which are mandatory as implied by the Consumer Guarantees Act 1993(NZ).

Local support
Please find local support at the following link address: dometic.com/dealer

Warranty conditions
The warranty covers manufacturing defects, materials and parts. The warranty does not cover fading of the cover and wear and tear due to UV radiation, misuse, accidental damage, storm damage, or permanent, semi-permanent or commercial use. It does not cover any resulting damage. Please contact your dealer for claims. This does not affect your statutory rights.
In addition, the warranty also does not cover the following cases:

  • Any damage from improper preparation before first use, such as weathering your product.
  • Accidental or malicious damage by negligence or faults caused by a failure to provide routine maintenance.
  • Accessories such as pegs and guy lines.
  • Repairs carried out by repair agents that are not authorized by Dometic.
  • Any loss or damage caused by a failure to follow the manufacturer’s instructions for usage, installation, operation or maintenance.
  • Damage/failure to operate caused as a result of improper installation or infestations of vermin, pests or insects.
  • Perceived faults where the product is operating within the normal range of Dometic performance specifications and these performance specifications were made known to you prior to purchase.

dometic.com

YOUR LOCAL DEALER
dometic.com/dealer

YOUR LOCAL SUPPORT
dometic.com/contact

YOUR LOCAL SALES OFFICE
dometic.com/sales-offices

A complete list of Dometic companies, which comprise the Dometic Group, can be found in the public filings of: DOMETIC GROUP AB • Hemvärnsgatan 15 • SE-17154 Solna • Sweden

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals