klass 3494674 Universal Remote Control User Manual
- June 16, 2024
- klass
Table of Contents
Universal
Remote Control
OPERATING INSTRUCTIONS
Please read this manual carefully before use, and keep it for future
reference.
Please read the user manual of your ceiling fan to learn about the electrical
connections of the remote receiver.
DANGER: Keep the remote control away from children.
SAFETY PRECAUTIONS
-
This appliance must be used under the rated voltage and frequency as indicated in rating label.
-
This appliance must be installed by a licensed and qualified electrician.
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. -
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
-
To avoid possible electric shock, be sure electricity is turned off at the main power box before installing your fan, disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location.
-
Use of unapproved remote control voids the warranty. Only use our remote control.
-
Never use accessories not recommended or supplied by the manufacturer.
REMOTE RECEIVER ELECTRICAL CONNECTIONS
WARNING! Make sure electricity is turned off at the main power box before starting work.
Slide the remote controller receiver unit into the slot on the mounting bracket.
Wire-in the remote controller receiverunit as shown in the figure below. Terminal block on the mounting bracket must be used between the receiver output wire and the motor wires. Terminal block provided separately along with the remote controller pack must be use to connect between the supply wire.
OPERATION INSTRUCTIONS
REMOTE CONTROL
The remote control uses radio technology. It is therefore essential that the
antenna of the receiver is not disturbed by a signal, try to isolate it to the
maximum and pay special attention not to bend the antenna cable.
The remote control generates more than one million codes, so it is almost
impossible for it to interfere with another remote control.
The optional functions are available depending on your ceiling fan model, specified on the user manual.
-
Switch On /Switch Off
-
Natural Wind
-
Speed
-
Timer / WiFi*
-
Light On / Light Off
Selection of colors for the light -
Dimmer + / -*
-
Selection of colors for the light*
-
Bip On / Off
-
Temperature*
-
Summer / Winter (Top = Winter, Bottom = Summer)
-
Configuration
*Optional
BEFORE USE
Pair your remote
When you connect your fan to the network for the first 30 seconds, a pairing
channel is opened. To pair your fan, press and hold the power button for 5
seconds in the 30 second period.
The fan responds with a long beep. To pair multiple fans with the same remote
control, repeat the operation with each fan. Your fan is now paired.
Configuring the remote control
This universal remote control is suitable for Klassfan ceiling fans, and must
be configured according to the characteristics of your fan model, depending on
the material and dimensions of the fan blades.
A program error can cause irreversible damage to your fan!
Please check the blade model of your fan and set the remote control with the appropriate program according to the table on the next page, to ensure the correct operation and the highest efficiency of the ceiling fan.
Configuration steps:
-
Press the power button to stop the fan.
-
Longpress the configuration button (backside left on the remote control).
When you hear a long “BEEP“ its entered the configuration mode. -
Short press the speed button according to the blades of your fan, 6 speed level matching 6 firmware. Confirming the last selection.
-
Long press the power button, the fan emits long “BEEPS”. Setting is finished.
- NOTE: Please do not press any other button during configuration, otherwise the configuration will stop.
OPERATION
1. On / Off: Press to switch on/off the fan.
2) Natural wind: Press once to turn on natural wind function. Press again to
turn off.
3) Speed: Press a speed button, the fan turns on in the selectd speed.
4) Timer : Press to select the operating time until it turns off (0.5h, 1h,
2h, 4h, 8h).
WiFi : Press the timer button for 5 seconds to enter the WiFi function, the
fan will beep continuously until the device is in the network (see the “WiFi
APP” section for configuration).
5) Light On / Light Off : Press to turn on / off the light.
6) Dimmer : Press + or – to change the intensity of the light.
5) or 7) Selection of colors of the light : RGB mode or Tone (3000/4000/6000
KV) depending on the model.
8) Bip On / Off: Press the button for 5 seconds so that the fan stops beeping.
9) Temperature : The control receiver has a thermostat to automate the change
of speed according to the temperature under the fan.
Press the temperature button to switch the fan to temperature mode.
In this pre-programmed mode, your fan will react as follows:
| Temperature | 0 ~ 19° | 19° ~ 21° | 22° ~ 24° | 25° ~ 26° | 27 ~ 28° | +29° |
|---|---|---|---|---|---|---|
| Speed | 1 | 2 | 3 | 4 | 5 | 6 |
In winter mode, it has the same operation but the blades turn in the opposite direction.
- Depending on the model
Summer/Winter
Attention! Do not change to one of these functions while the fan is still
rotating, this can severely damage it.
The summer/winter function allows you to change the direction of rotation of
your fan.
To do this, wait for your fan to stop completely, then press the direction
button, and select a speed.
You will not feel the moving air under the fan anymore, because the air is now
circulating to the top of the room, which allows to homogenize the room
temperature without having direct air flow.
This function is ideal for the winter as it allows warmer air to circulate,
usually located at the upper parts of the room, to come down so you can feel
it. On average, in winter, there is a temperature difference down at the floor
and up at the ceiling between 5 and 10° C.
In the summer, if you use an air conditioner, the effect is the same but
reversed, because the cold air is very dense and usually stays at 1 meter from
the floor.
This mode therefore saves a lot of the heating or cooling expenses!
In summer mode, for an optimal efficiency, the blades should be between 2.5
and 3 meters above the floor.
In winter mode, the fan must be placed between 50 cm and 1 meter from the
ceiling. Call your distributor for more details.
Memory functions
Depending on the model of your fan, it can have some memory functions
available, this allows more convenient operation with the switch.
When you leave the room, if you turn off your fan with the switch, the latter
will memorize the last programmed mode.
Example: in a ceiling fan with light, you go out of the room with the light on
and ventilation in Speed 2, you turn off the fan with the switch. When you
return, using the switch, your fan will turn on the light, and set the fan to
Speed 2.
WIFI APP
Installation
- You can scan this QR code to download the Smart Life app You can also search “Smart Life” in major application markets to install the app. https://smartapp.tuya.com/smartlife
- Click “…” in the upper right corner, select “Open in Browser”, and then click “Download“.
- After the installation is successful, open the software.
Register an account and log in
If you do not have an app account, you may choose to register or log in by
authentication code.
- Click “Register” to go to the Smart Life privacy policy page.Click “Agree” to proceed to the registration page.
- The system will identify automatically the country/region you are in,or you may choose to select manually a country/region. Enter your mobile phone number or email and click “Get authentication code”.
Enter the authentication code you received. Then enter the password and click “Completed” to complete registration.
-
Account ID + Password Login
Enter the mobile phone number or email you have registered and enter the password in to log in. -
Verification Code Login
-
- Click “Verification code login” to go to the next page.
- The system will identify automatically the country/region you are in, or you may also choose to select manually a country/region.
- Enter your mobile phone number or email and click “Obtain authentication code“.
- Enter the authentication code in the text message or email to log
in.
WIFI connect
- First ensure that wifi can be used normally.
- Click “Add Device”, first select “Home Appliances II”, then select “Fan”.
- Press and hold the “Timer” button of the remote control for more than 5 seconds. Wait until the ceiling fan receiver emits a BeeBee sound continuously.
- Select the correct wifi source, then enter the wifi password and click “Confirm” to wait for the connection.
- Wait for the connection to succeed.
Multiple members control the same device or multiple devices
- You can enter the single device control page in the app, click on the upper right corner “ “ to enter more functions, click on “Share Device” -> “Add Share”. Enter the phone number of the other user and click Finish to share the device with other members.
Note: The above method requires the other User to have an APP account. - The simplest way to share is to use a public account to log in.
For more information, go to the “Me“ -> “Help Center” in the app.
RECYCLING
Plastic and cardboard packaging can be recycled. Separate and dispose of each material in the appropriate recycling container. Consult your local authorities for more information on recycling.
DISCARDING WORN HOUSEHOLD DEVICES
**** The European directive 2012/19/EU pertaining to electrical and
electronic waste prohibits such household goods from being discarded with
local refuse services. Worn devices must be collected separately to optimize
the recovery and recycling rates of the components therein to reduce
detrimental effects on the environment and on human health.
RECYCLING OF USED BATTERIES AND ACCUMULATORS
**** The remote control is battery operated. According to the European
Directive 2006/66/EC on batteries, accumulators and rechargeable batteries,
batteries must not be disposed of with household waste. Please inform about
local regulations for the disposal of batteries. Proper disposal protects the
environment and human health.
In accordance with European directives applicable to this product.
Customer service:
aftersales@klassfan.com
contact@klassfan.com
Tel : +34 960 082 885
IMPORTER / IMPORTADOR:
CLIMACITY S.L.
C. Torrox 2 – 5, 28041 Madrid, Spain
contact@klassfan.com
www.klassfan.com
References
- KLASSFAN Premium Ceiling Fans
- Que Faire de mes Déchets ? Découvrez les solutions pour tous vos déchets et nos conseils pour en produire moins.