Wuyi E9G Electric Scooter 2 Wheels 10 Inch 500W User Manual

User Manual

Electricscooter
E9G

E9G Electric Scooter 2 Wheels 10 Inch 500W

Welcome to use
Thank you for choosing ZAMELUX electric scooter (hereinafter referred to electric scooter, electric scooter is a stylish sports entertainment equipment

Product and parts

Access Please carefully check whether the contents of the box are intact.

Functional Sketch

The control panel

Speed display| Step 1: after power on, after the throttle is increased to 16 (digital display on the display screen), press the brake handle while pressing the throttle to release the password. Step 2: after releasing the password, the car will enter the gear mode before power off by default. Step 3: pedestrian mode: the maximum speed is 6km/h, and the tail light flashes after entering pedestrian mode; Speed limit: only the first mock exam can reach the 6km/h speed, release the throttle and release the pedestrian mode.
---|---
Battery indicator| There are five electric lights to indicate the amount of electricity. When 5 lights are on, the electricity is between 100%-80%; when 4 are lights on, the electricity is between 80%-60%. When the battery is used up, the four lights are all extinct, and the scooter will slide to the natural stop by inertia, please recharge it before using.
Power switch| When the scooter is power on, short press the switch to open the vehicle; long press the switch for 2S can turn it off. After turning on the vehicle, short press the switch can turn ON/OFF the Light; Press the switch twice in a row, switch between comfortable and sport mode.
Cruise control| –     Activate CRUISE CONTROL mode: press and hold the accelerator lever at the same speed for 5 seconds.
–  will turned off (when decelerating, the cruise control mode is turn off).

Body assembly

1. Secure the scooter standpope and open the parking bracket.
2. Install the crossbar on the Standpipe
3. Use the hex wrench in the packing box to lock screws on both sides.
4. After the completion of the installation to carry out switch detection.

Charger connection

1. Open the  rubber stopper 
2. Insert the charging plug
3. After checking, close the rubber stopper

Learn to drive

There is a risk of falling injury during the study period, so please wear a helmet and a protective gear as shown

1. Turn on the power and check the power indicator
2. Single feet stand on the board, the other foot pedal back.
3. After electric scooter slide, the other foot pedal, when feet remain stable, tap the port finger (to be Skm / h above the speed will ~start the throttle
4. Release the throttle finger can slow deceleration, energy recovery system automatically open to help slow down, emergency brake need to shake the brake,handle at the front left handle.
5. When the focus is slightly tilted to the steering direction, and slowly tum the handle

Safety instructions

Avoid security risks Please avoid riding in the rain Encounter deceleration zone/elevator threshold/potholes and other unconventional road pavement, please do not pass at high-speed. Encounter rough road, please keep in the low speed (5-10km/h). A slight kneeling allows you to better adapt to the complex road To avoid the head hit the door frame, elevators and other obstacles Do not accelerate at downhill Do not press the throttle when walking Please avoid obstacles to ride the electric scooter ** Do not hang heavy objects such as backpack on the handlebar
Do not try the dangerous actions ** Do not ride on the pedal or on the ground Prohibit the ride electric scooter into the motor scooter lane and the car mixed with the residential It is forbidden to turn the handle at high speed It is forbidden to travel in more than 2cm-water Prohibit many people at same time driving an electric scooter or driving with children It is forbidden to step on the back of the fender Do not touch the disc brakes It is forbidden to not hold the handlebar when driving It is forbidden to ride electric scooters upstairs and downstairs or jump obstacles

Safety instructions

• Anelectric scooter is a sporting entertainment tool that is not a scooter, but once you drive it into a public area, it will also have a scooter property, so there are also possible safety risks for all modes of transport.
  Strictly following the instructions in this manual to drive for the maximum extent to protect you and the others’s safety, and to ensure compliance with national and provincial traffic regulations and traffic regulations.

• Atthe same time, you need to understand: Once you have an electric scooter on a public road or other public place, you may be exposed to the risk of unauthorized driving/improper operation of others or scooters, even ifyou are in full compliance with this  safe driving guide. Like walking or cycling may also be hurt by other means of transport. As with all scooters, the faster the electric scooter is driving, the longer the brakes need, and the emergency brakes on some smooth surfaces can also cause the wheels to slip and lose balance or even fall. Therefore, it is important to be vigilant and maintain the proper speed during driving, ad it is important to maintain a reasonable safety distance with others and the transport means. Please be vigilant and drive at low  speed before entering unfamiliar terrain.

• Please respect the right of pedestrian way when driving. Avoid frightening pedestrians, especially the children. When pedestrians passing through, remind pedestrians and slowing down when passing. As far as possible from the left side of the pedestrian (applicable to the country where the scooter is traveling right). Face to face with pedestrians, keep on the right and lower speed.

• We must strictly follow the safety requirements of this manual for drivers in countries and regions, where there are no national standards and regulations for electric scooters, such as in China. The seller shall not be liable for any liability, personal injury, accident, legal dispute, and all other unfavorable events resulting from the use of violating the instructions indicated in this manual.

• Do not lend the electric scooter to a person who does not operate to avoid injury. If give the electric scooter to a friend, be sure to be responsible for the safety of your friends, you should teach him(her), and tell him(her) must wear safety care.

• Please check the electric scooter for each time before driving. If you find that the parts are loose, the battery life is obviously reduced, the tire is slow to leak or excessive wear, turn to abnormal sound or malfunction, please stop using it immediately, and don not driving force.

Folding and transporting

Make sure that the electric scooter is tured off, standpipe will dip through folding, open the folding wrench, and aim at the bell position and hook the bell with the rear mudguard. When opening you need to press the bell hook at the hook, until the bell hook is  out of the stall after the hook, the vertical standpipe and lock folding plate back to fold. After folding, hold the standpipe with one hand or both hands to transport.

Daily maintenance

Electric scooter cleaning and storage
If the electric scooter body surface cracks, please use a soft cloth dipped in a small amount of water to wipe; if there is difficult to clean the dirty, you can use toothpaste and wash with a toothbrush repeatedly, and then use a damp cloth to clean. If there are scratches in body plastic, you can use sandpaper or other grinding materials to polish.
Prompt: Do not use alcohol, gasoline, kerosene or other corrosive, volatile chemical solvent cleaning, otherwise it will seriously damage the appearance and internal structure of the body. It is forbidden to use a pressure water gun to spray and flush,and ensure that the electric scooter is closed all along and the the charging cable has been unplugged and the rubber cap is tightened. Otherwise, it may cause electric ~shock or serious failure due to internal water intake.
When not in use, try to store electric scooter s and tire aging and reduce the lift of electric scooters and their battery pack.

Electric scooter battery maintenance

1. Do not use other models or brands of batteries, or there may be a security risk.
2. Do not touch the battery contacts, and do not open or expose the shell. Avoid metal objects touching the battery contacts to cause a short circuit. Or it may cause damage to the battery or personal injury or death.
3. Only use the original charger to charge, otherwise there is a risk of damage or fire.
4. Improper disposal of used batteries may cause serious contamination of the environment. Observe local regulations when discarding this battery pack. Do not dispose of the battery pack, to protect the natural environment together.
5. After each use, please recharge the battery and then store, and it is conducive to extend battery life.

Do not place the battery in a high temperature environment higher than 50° C or below -20° € (for example, do not place the electric scooter or its battery pack put it under summer exposure in a car), and do not put a battery into a fire. Otherwise it may lead to battery failure, overheating, and even fire risk. When not using for more than 30 days, please be fully charged, stored in a cool dry place, and fully charged every 60 days, or it may damage the battery, and this damage is not within the warranty.
To avoid the full exhaustion of electricity and recharge, as far as possible with the charge with the use, which can greatly extend the battery life. In addition, at room temperature, the battery pack can play a higher mileage and performance; And if it is used in an environment below 0° C, battery life and performance will drop. Typically, at 20° C, the mileage may be only half or less at room temperature. And the temperature rises, the battery milcage will be restored.
Prompt: A fully charged electric scooter, depleting its stored power after about 120-180 days of standby. The battery inside has the smart chip to record the battery charge and discharge situation, and prolonged non-charging damage will not be recharged, at this time if not timely charging, it is likely to lead to excessive battery discharge damage, this damage is irreversible, and can not enjoy free warranty. (Note: Non-professional personnel is prohibited to the remove the battery pack, or it may be lead to serious security incidents due to electric shock or short circuit!)

Disc brakes debugging If you feel the brakes are too tight, please use the M5 hex wrench counterclockwise to release the pressure plate screws on the disc brake seat, return the brake line to make the exposed tail length slightly shorter, and lock the pressure plate screws; If you feel the brake is too lose, release the pressure plate screws, drag the brake cable to make the exposed tail length slightly longer, and then lock the pressure plate screws.

Handle shake debugging ![Wuyi E9G Electric Scooter 2 Wheels 10 Inch 500W

• Figure 38](https://manuals.plus/wp-content/uploads/2024/01/Wuyi-E9G- Electric-Scooter-2-Wheels-10-Inch-500W-Figure-38.jpg)If your standpipe in electric scooter is shaking, please use the M5 hex wrench to lock the two screws at the fold mechanism.

Extend the use of inflatable mouth If your electric scooter front and rear tires are deficency, please use the extended inflatable mouth to connect the scooter body tires to cheer. First remove the front and rear tire inflatable mouth cup, and then tighten the extension of the inflatable mouth and tire inflatable mouth, and connect the pump to inflate after they are to be tightened

Model parameter table

wide channel
Working temperature °C| -10~40
Storage temperature °C| -20~45
Protection levels| IP54
Battery parameter| Rated Voltage (VDC)| 36V
| Max charging voltage （VDC）| 42V
Motor parameter| Rated input voltage (VAC)| 110-240V
Rated output voltage (VDC)| 42V

1. Body height: the distance from the ground to the top of its body.
2. Typical life: When the electric scooter is full, 75kg load, 25 degrees Celsius, flat road without wind environment, in the energy-saving mode to keep at 15kmvh even speed conditions measured, the actual life due to load, temperature, wind speed, road and operating habits and other factors to be different.

Note: Data and parameters vary with different models. Subject to change without notice.

Name and content of harmful substances in the product

This table is formulated in line with the SJ/11364.
O: Indicate that the content of this harmful substance in all homogeneous materials of this components is below the limit prescribed in GB/T 26572
X: Indicate that the content of this harmful substance in at least one homogeneous materials of this components is beyond the limit prescribed in GB/T 26572

o tight, please use the M5 hex wrench counterclockwise to release the pressure plate screws on the disc brake seat, return the brake line to make the exposed tail length slightly shorter, and lock the pressure plate screws; If you feel the brake is too lose, release the  pressure plate screws, drag the brake cable to make the exposed tail length slightly longer, and then lock the pressure plate screws. Handle shake debugging If your standpipe in electric scooter is shaking, please use the M5 hex wrench to lock the two screws at the fold mechanism.
Extend the use of inflatable mouth If your electric scooter front and rear tires are deficency, please use the extended inflatable mouth to connect the scooter body tires to cheer. First remove the front and rear tire inflatable mouth cup, and then tighten the extension of the inflatable mouth and tire inflatable mouth, and connect the pump to inflate after they are to be tightened

Warranty Terms and Conditions and Warranty Claims

Scooter Warranty
The Scooter Warranty is 1 year from the date of purcharse, except the battery.
Battery Warranty
The Battery Warranty has a term of 6 months from the date of purchase of the electric scooter.
Packaging
The retum must be made in the original packaging. Shipping products in the other types of packaging than the original may affect its operation.
Purchase ticket or invoice
It must be presented some identification of the center where the product was purchased.
Merchandise Identification
The merchandise must be perfectly identified with the reference number assigned by the Technical Service when it is contacted to manage the warranty. In the event that said number does not appear, the Technical Service is not responsible for the possible loss of the electric scooter.
Description of the problem
It is mandatory to fill in the field “DAMAGE DETAILS” an explanation as detailed as possible of the problem presented diagnosis and subsequent repair will be facilitated.
Form
All fields in the form in which the asterisk appears are mandatory and this action must be performed correctly.
Packaging Status
If the box arrives with obvious damage, the warranty is not met. We recommend taking photographs before collecting it for subsequent claim to the transport company.
Electric Scooter Reset
Once the product has been received, it must be reset as indicated in the manual and, if it retums to its original operation, the customer must pay the transport cost plus an expense for the working time used by the technician.
Symptoms of Misuse
If the product shows clear symptoms of misuse, the customer must pay the cost of transport plus an expense for the technical work performed. The product will be sent once the transfer is received. If requested by the customer, repair budget will be made.

Battery
The battery has a limited duration in terms of charge cycles. Keep in mind that this may affect the storage temperature and humidity in the area. Therefore, battery problems caused by wear, sulfation and physical damage would not fall into the category of manufacturing defects, so the warranty would not cover it. Batteries under nomal conditions do not discharge. Any doubt in its manipulation consult the User Manual.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>