BURLEY 960047 1-Wheel Stroller Kit Instruction Manual

June 5, 2024
BURLEY

BURLEY 960047 1-Wheel Stroller Kit

BURLEY-960047 1-Wheel-Stroller-Kit-

Box Contents:

  • 1 Stroller Kit, 1 wrist tether, 1 manual, 1 hex key
    Required Tools:

  • 5mm hex key (included), 10mm wrench (not included)

Installing Your Stroller Kit

  1. Remove nut and bolt from tow bar end. Discard bolt and lock nut. Safety strap and D-ring will be re-installed.
  2. Remove nut and bolt from stroller kit. Slide stroller kit onto tow bar as shown (Figure 1).
  3. Place D-ring and safety strap on supplied 6mm x 50mm bolt. Line up holes in stroller kit, tow bar and flex connector and install bolt (Figure 2). BURLEY-960047 1-Wheel-Stroller-Kit-fig-2

Installing Wrist Tether

  1. Wrap wrist tether around the center of the handlebar. Insert end of wrist tether with large loop through small loop on opposite end (Figure 3).
  2. Pull tether to tighten securely.

Converting to Stroller Mode
Pull fork as shown (Figure 4), then rotate wheel down fully. Fork will automatically rise into the locked position. BURLEY-960047 1-Wheel-Stroller-
Kit-fig-4

Adjusting Tow Bar for Strolling

  1. Remove lock pin from tow bar mount.
  2. Press the button on tow bar and slide tow bar towards the rear of trailer (for trailers with plastic tow bar mounts, the button is pressed by fully opening the wheel guard) (Figure 5).
  3. Align hole on tow bar mount with front hole on tow bar. Reinstall lock pin and close the retainer. BURLEY-960047 1-Wheel-Stroller-Kit-fig-5

Converting to Trailer Mode

  1. Return tow bar to fully extended trailer position (See page 5).
  2. Pull fork down (Figure 6) and rotate into stroller mode as shown. Fork will automatically lock into trailer position when positioned correctly.

Warning
The stroller wheel must always be folded up, in trailer mode, before pulling behind a bicycle. Failure to position the stroller wheel in trailer mode before cycling could result in an accident and serious injury or death. BURLEY-960047 1-Wheel-Stroller-Kit-fig-6

Safety Guidelines

Protect Your Children
Never leave your children unattended in the Stroller and always use the handlebar tether. Use the shoulder harnesses and lap belts to securely hold your children in the Stroller at all times. For maximum stability and safety, seat a single child in the center. Periodically check the placement of the shoulder straps, especially for sleeping children. Make sure children cannot put a finger into the wheel spokes.

Loading Your Stroller
Do not overload your Stroller. The maximum load limit for children and/or cargo are 75 lbs. (34 kg.) for single child trailers and 100 lbs. (40 kg.) for double child trailers. When placing children or cargo into the Stroller, keep the load centered and forward of the axle. Pack the load as low as possible and make sure items cannot shift. Loose, heavy objects can injure passengers in the event of a sudden stop or tip over.

Use Your Flag
Always use the safety flag-it will help make the trailer visible.
Observe Age and Height Restrictions
The Stroller seat is intended only for children old enough to sit upright and alone. Adequate neck strength is required to hold his/her head upright. A physician should evaluate anyone who is of questionable developmental age for using this Stroller. Never carry a child whose sitting height is above the roll bar, because their chance of injury is significantly higher in the event of a tip over.

Walk on Suitable Surfaces
Use the Stroller only on paths that are meant for walking. Do not use it on steep slopes, which can make the Stroller unstable. You should be able to maintain traction and control at all times. Do not maneuver the Stroller over stairs or other obstacles while your child is inside. Never use your Stroller with inline or roller skates.

Burley Limited Warranty

This Burley accessory is warranted from the date of purchase against defects in materials and workmanship as follows: frame and plastic parts for two years.
Your original dated sales or delivery receipt showing the date of purchase is your proof of purchase. If a defect in materials or workmanship is discovered during the Limited Warranty period, we will, at our sole option, repair or replace your product at no cost to you. This warranty is only valid in the country in which the product was purchased. The Limited Warranty extends only to the original retail purchaser of this product and is not transferable to anyone who obtains ownership of the product from the original purchaser.

The Limited Warranty does not cover claims resulting from misuse, failure to follow the instructions, installation, improper maintenance and use, abuse, alteration, involvement in an accident, and normal wear and tear. The Limited Warranty does not cover products which are used in rental operations and Burley will not be liable for any incidental or commercial damages relating to such use.
TO THE GREATEST EXTENT PERMITTED BY LAW, THIS LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTY, WRITTEN OR ORAL, INCLUDING BUT NOT LIMITED TO ANY EXPRESS OR IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
The duration of any implied warranties, including any implied warranty of merchantability or fitness for a particular purpose that may exist during the express warranty period is expressly limited to the limited warranty period. Some states and countries do not allow limitations on how long an implied warranty lasts; therefore, the above limitations and exclusions may not apply to you.

THE CUSTOMER’S EXCLUSIVE REMEDY FOR BREACH OF THIS LIMITED WARRANTY OR OF ANY IMPLIED WARRANTY OR OF ANY OTHER OBLIGATION ARISING BY OPERATION OF LAW OR OTHERWISE SHALL BE LIMITED AS SPECIFIED HEREIN TO REPAIR OR REPLACEMENT, AT OUR SOLE OPTION. IN ANY EVENT, RESPONSIBILITY FOR SPECIAL, INCIDENTAL AND CONSEQUENTIAL DAMAGES IS EXPRESSLY EXCLUDED.

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
This Limited Warranty gives you specific legal rights, and you may have other rights that vary from state to state or country.
For warranty service or replacement part information for the USA or Canada, please contact Burley directly by calling 800-311-5294 or emailing burley@burley.com. For warranty service or replacement part information outside the USA and Canada please contact the place of purchase for warranty service. Please be prepared to provide the product model, serial number and a description of the warranty issue.
Some replacement parts may be available for purchase after this limited warranty expires. Please visit us at www.burley.com or call us at 541-687-1644 for more information.

CONNECT WITH BURLEY:
Whether you ride your bike all year long or are a fair-weather rider, Burley shares your enthusiasm for making the most of your bike. Thank you for your business. We appreciate it.

BURLEY DESIGN
1500 Westec Drive
Eugene, OR 97402
P. 541.687.1644 or 800.423.8445
F. 541.687.0436
burley@burley.com
©2015 Burley Design LLC
“Burley” is a registered trademark of Burley Design LLC 170117 1-Wheel Stroller Kit Rev1

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals