PERFECT Y241 RC Car Instruction Manual

: June 16, 2024
: PERFECT

Table of Contents

PERFECT Y241 RC Car
Product Information
Specifications
Product Usage Instructions
FAQ
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PERFECT Y241 RC Car

Product Information

This product is a radio or TV equipment that is designed to comply with Part 15 of the FCC Rules. It is intended to be used for receiving radio or television signals. The device operates under the following conditions:

The device must not cause harmful interference.
The device must accept any interference received, including interference that may cause undesired operation.

Specifications

Compliance: Part 15 of the FCC Rules
Usage: Receiving radio or television signals

Product Usage Instructions

Antenna Placement
To ensure optimal reception, follow these guidelines:

Reorient or relocate the receiving antenna if the signal quality is poor.
Increase the separation between the equipment and the receiver.

Power Connection
Follow these steps to connect the equipment to a power source:

Plug the equipment into an outlet or a circuit different from the one to which the receiver is connected.

FAQ

Q: Can I connect the equipment to the same circuit as the receiver?

A: It is recommended to connect the equipment to a different outlet or circuit than the one used by the receiver.

).push({});

If there’s more than one car played in the same place, set the cars to different frequencies to avoid mutual interference
Do not bend the antenna or point ital other people or articles to avoid hurts
Do not play in a place with puddles, mud, or sand
Do not play on the roads or in any other dangerous places to avoid accidents

For the best stunt performance, make sure the tires are clean. If the tire is dirty, gently wipe it with a clean damp cloth. Do not soak toys in water.

BATTERY SAFETY

The placement or replacement of batteries is to be performed by an adult.
Remove the rechargeable battery from the chassis before charging.
P-Jways removes exhausted batteries from the car and the transmitter.
Make sure the main switch is set to OFF before installing the battery pack into the car body.
Batteries must be inserted with the correct polarity.
Non-chargeable batteries shall not be recharged.
Do not short-circuit the batteries.
P-Jways remove the batteries from the car and the transmitter after playing.
Never throw the batteries into fire to avoid explosion or leakage.
Do not mix batteries from different producers or new and old batteries.
You should only use batteries of the same or equivalent types as recommended.
Check the batteries on a regular basis to avoid leakage.
Keep this manual well for future reference as it contains important information about this product.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions
- his device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.