OEDRO OETESS-0038 Running Boards Instruction Manual

June 16, 2024
OEDRO

OEDRO LOGO CARE AND USE INSTRUCTIONS
OETESS-0038
OETESS-0063 

Before Installation:

Read this instruction carefully before starting installation.
Proper tools will improve the quality of installation and reduce the time required. Does NOT compatible with diesel engine vehicle.
If missing parts or any damage found, please take a picture and contact us.
Professional installation would be highly recommended.

Step 1:

  1. Locate (4) mounting positions each side.
  2. Remove rubber plugs on inner rocker panel.
  3. Insert clip nuts onto existing holes in the inner rocker panel.

Note: Some vehicles may equipped threaded inserts in rocker panel, use them directly in the step 2.

OEDRO OETESS 0038 Running Boards - rocker panel

Insert M8 clip nut onto the large hole and over the smaller hole next to it, with threads inside of the inner rocker panel.

OEDRO OETESS 0038 Running Boards - Clip Nut

Step2:

  1. Attach the bracket to the inner rocker panel and secure with (1) M8 hex bolt, (1) M8 flat washer.
  2. Secure the bracket to pinch weld with (1) M8 hex bolt, (1) M8 flat washer, (1) M8 hex nut.
  3. Repeat to install remaining brackets, do not fully tighten.

OEDRO OETESS 0038 Running Boards - Flat washer

Note:
For vehicle with factory threaded inserts and weld nuts, clean the rust and dirt around the threads before installation. Proper lubrication is required.

OEDRO OETESS 0038 Running Boards - Weld nut

Step 3:

  1. Remove (8) M8 hex bolts and (8) M8 flat washer from the step bar.

  2. Slide mounting tracks to proper positions.

  3. With assistance, lift and attach the step bar to brackets.
    Secure the step bar on brackets with (8) M8 hex bolts and (8) M8 flat washers.

  4. Repeat to install the other side step bar, do not fully tighten.

OEDRO OETESS 0038 Running Boards - Hex bolts

Step 4

  1. Tighten M8 hex bolts and nuts on vehicle with 15 ft-lbs. torque.
  2. Adjust the step bar to level and tighten M8 hex bolts with 15 ft-Ibs. torque.
  3. After the step bar installed, periodic check to ensure all mounting hardware remains secure and tight.

Part List:

OEDRO OETESS 0038 Running Boards - Parts List

| Qty.| Description
---|---|---
1| x 8| Mounting Bracket
2| x 16| M8 Hexagon Flange Bolt
3| x 16| M8 Flat Washer
4| x 8| M8 Hexagon Flange Bolt
5| x 8| M8 Flat Washer
M8 Hexagon Flange Nut
6| x 16| M8 ClipNut
7| x 16| Pre-Install on Step Bar

OEDRO LOGO

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals