OEDRO OETESS-0059 Running Boards Instruction Manual
- June 16, 2024
- OEDRO
Table of Contents
CARE AND USE INSTRUCTIONS
OETESS-0059
OETESS-0059 Running Boards
OETESS-0059
Tools Required
- 13mm, 16mm Socket
- 16mmWrench
- Ratchet
- Torque Wrench
Notes
Read this instruction carefully before starting installation.
Proper tools will improve the quality of installation and reduce the time
required.
If missing parts or any damage found, please take a picture and contact us.
Professional installation would be highly recommended.
Periodic check to ensure all mounting hardware remains secure and tight.
Step 1:
- Locate (4) mounting positions each side.
- Remove factory plugs from mounting positions.
- Clean the sealant and dirt around mounting positions.
Step 2:
- Attach bracket to the rocker panel and secure with (2) M8X30 hex bolts, (2) M8 flat washers, (2) M8 lock washers.
- Repeat to install all brackets. Do not fully tighten.Front/Center Passenger Side Bracket
Rear Passenger Side Bracket
note:
The rear bracket is in the opposite direction to the front and center brackets.
Step 3:
- With assistance, lift and attach the step bar to brackets. Secure the step bar on brackets using (8) M10 hex bolts, (16) M10 flat washers, (8) M 10 lock washers, (8) M 10 hex nuts.
- Repeat to install the other side step bar.
Step 4:
- Tighten M8 hex bolts on vehicle with 15 ft. lbs. torque.
- Adjust the step bar to level and tighten MlO hex bolts and nuts with 31 ft. lbs. torque.
- After the step bar installed, periodic check to ensure all mounting hardware remains secure and tight.
note:
The rear bracket is in the opposite direction to the front and center
brackets.
Part List
- FL=Front Driver Left Side
- CL=Center Driver Left Side
- RL=Rear Driver Left Side
- FR=Front Passenger Right Side
- CR=Center Passenger Right Side
- RR=Rear Passenger Right Side
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>