Seeutek 48 Inch Manual Tile Cutter with Tungsten Carbide Scoring Wheel User Guide
- June 16, 2024
- Seeutek
Table of Contents
Manual Tile
Cutting Machine
Installation Instruction
48 Inch Manual Tile Cutter with Tungsten Carbide Scoring Wheel
Make work easier
Please read the Instructioncarefully before installing and usng this product.
Keep the user manual in good place for reference
Using Method
-
Position
Move ine scale tc select the culling size Instali the cutter wheel and puil the handle to the end.
Atace tne tile honzontally on the base. aligned with the scale. -
Cutting
Denrass the handie and push 4 forward the cutter wheel cuts a continuous, even lne across the surface of the tile. -
After cutting, slightly lft the handle up so that the rubber piece is fevel with the the. Press down on the handle and the tile will break along the cutting line.
Suggestion
Whether the marked kine is even, continuous and clear all the way ts the key whether it can cut the tile praperly. The knife wheel is made tram special super hard alloy, whose hardness far exceeds that of tie surface. Therefore, « can mark a cutting line only by using very smal force to hold the handie to push the knife wheel gently and smoothly. In the process of cutting the tie, the main force 1s not on marking off, which is the same as cutting glass. Marking aff too strongly does not only make the cutting line become sawtooth, but aiso makes break of yellow blade of super hard alloy. which greatly reduces normal service life af {he knife wheel.
-
Type of tile that can be cut
Wail brick
POUSNINE Brice
Glazed ceramic tia
Cutting tecenesy 6 rim -
Cannot cut tile types
The marble
Grane
Ties with oneven surface
Microcrystalline stone sarface with 0.5-3 crystal layerd -
Laser installation and laser offset adjustment
Note: Adjust the laser before use
1. Install the battery, Open the battery cover on the laser case, instal two T# batteries, dived into positive and negative electrodes, Mace in the laser battery case.
2. Turn on the laser switch to check whether the beltery s property Installed. Finatly, Install the battery case cover.
3, When the laser ling shows a left-right offset, adjust the screws at both ends of the laser leans.
4. If the laser jine offset the right, !cosen the ight screw and tighten the left screw. Adjust the laser to the center of the cutter wheel,
5, Simularty, if the laser lime offset to the laf Reverse adjustment according to the above method.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>