audiolab DC BLOCK Smart Phone Device User Manual
- June 16, 2024
- audiolab
Table of Contents
DC BLOCK Smart Phone Device
User Manual
DC BLOCK Smart Phone Device
DC BLOCK
User Manual
3 YEAR WARRANTY
Scan the QR code using a smart-phone device, for product warranty registration
online.
Important Safety Information
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding plug
has two blades and a third grounding prong. The wide blade or the third prong
is
provided for your safety. If the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete outlet.
Protect the power cord from being walked on or pinched particularly at the
plugs, convenience receptacles, and at the point where they exit from the
apparatus.
Unplug this apparatus during lightning storms or when unused for long periods
of time.
Refer all servicing to qualified service personnel. Servicing is required when
the apparatus has been damaged in any way, such as power supply cord or plug
is damaged, liquid has been spilled or objects have fallen into the apparatus,
the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
CAUTION: These servicing instructions are for use by qualified service
personnel only. To reduce the risk of electric shock, do not perform any
servicing other than that contained in the operating instructions unless you
are qualified to do so.
Do not install this equipment in a confined or built-in space such as a
bookcase or similar unit, and keep well ventilated in open space. The
ventilation should not be impeded by covering the ventilation openings with
items such as newspaper, table-cloths, curtains etc.
WARNING: Only use attachments/accessories specified or provided by the
manufacturer (such as the exclusive supply adapter).
WARNING: Please refer to the information on the exterior panel of the
enclosure for electrical and safety information before installing or operating
the apparatus.
WARNING: To reduce the risk office or electric shock, do not expose this
apparatus to rain or moisture. The apparatus shall not be exposed to dripping
or splashing and that objects filled with liquids, such as vases, shall not be
placed on apparatus.
WARNING: For the terminals marked with symbol of” ” the voltage may be of
sufficient magnitude to constitute a risk of electric shock. The external
wiring connected to the terminals requires installation by a qualified person
or the use of ready-made leads or cords.
The product is designed to use in moderate/tropical climates.
Mains Supply: The mains operating voltage of Audio lab DC BLOCKER is
shown on the rear panel. If this voltage does not match the mains voltage in
your area, consult your Audio lab dealer about converting the unit.
The mains supply fuse on the rear panel is accessible when the ie mains plug
has been removed. In the rare event that it has broken, check for any obvious
cause before replacing the fuse with one of the correct rating and type.
The fuse values are: 100-240V T4AL Slow Blow
**** This equipment is a Class II or double insulated electrical appliance.
It has been designed in such a way that it does not require a safety
connection to electrical earth.
audio lab DC Block – Mains Conditioner (DC+RF filter)
Quick Instruction Guide
Functions:
- High frequency filter suppressing noise on the mains power line.
- Blocks DC on the mains power line.
Unpacking:
Unpack the product fully, the carton should contain:
- The audio lab DC BLOCK
- One IEC mains power cord suitable for your area
- One IEC C14 to C13 jumper cord
If an item is missing or damaged report this to your dealer as soon as
possible.
Retain the packing for safe transport of your unit. If you dispose of the
packing, do so with regard to any recycling regulation in your area.
Connection:
Make sure the ON/OFF switch on the unit you are going to use is switched off
before the operations below.
(1) Connect the supplied jumper cord from the output of DC BLOCK to the unit
you are going to use (ie. audio lab power amplifier)
(2) Connect the supplied mains power cord from the input of DC BLOCK to the AC
supply outlet
Specifications:
*Peak Load: | 1 00-240V – 50-60Hz |
---|---|
Audio Power Amplifier Compatibility: | 600VA |
Audio Power Amplifier Compatibility: | < 2×1 SOW or < 1 x300W |
Dimensions (W H x D): | 113 x 59 x 140 (mm) |
Weight (net): | 0.7kg |
*Note
The DC BLOCK is designed for audio equipment with variable power requirements
up to maximum peak load, and should not feed any permanent high power loads
such as heaters or similar.
Warranty Coverage
Audio lab warrants its products, subject to the following terms and conditions below, to be free from defects in materials and workmanship.
Online Registration
https://qrco.de/audiolab-warranty
Scan the QR code using a smart-phone device, for product warranty registration
on line.
The three (3) year extended warranty is applicable to items purchased from Jan
1st 2021, onwards.
Items purchased prior to this date are not eligible for this extended warranty
service but are subject to statutory warranty claims and all applicable
consumer rights.
To qualify for the extended 3 year warranty, you must register your product
within ninety (90) calendar days from the date of purchase. Visit audiolab.co
.uklwarranty-registration to
complete your online registration. Items not registered online will have a
Limited Warranty for one (1) year, or for the period of your country’s
statutory warranty, whichever is longer.
Warranty can only be offered to products registered with proof of purchase
with date, model and details of the authorised dealer clearly stated on the
receipt/invoice. Please keep the original receipt/invoice in case it is
required for a warranty claim.
This Limited Warranty is non-transferable and is offered exclusively to the
original owner.
This Limited Warranty is valid only in the original country of purchase.
Repairs or replacements are provided under this warranty are the exclusive
remedy of the consumer. Audio lab shall not be liable for any incidental or
consequential damages for breach of any expenses or implied warranty with any
product. Except to the extent prohibited by law, this warranty is exclusive
and in lieu of all other warranties whatsoever, both expressed and implied,
including but not limited to the warrant of merchantability and fitness for
practical purpose. This warranty provides benefits that are additional to and
do not affect your statutory consumer rights.
This Limited Warranty offer is subject to correct information being submitted
in your application. Incorrect dates or mismatched purchase receipt dates that
are outside of the warranty terms will immediately invalidate any warranty
claim. *Please check with your dealer local distributor for further
information.
Exclusions
The following items are excluded from the Audio lab warranty:
Normal wear and tear and cosmetic damage (including but not limited to any
wear from reasonable use, environmental deterioration or neglect)
Products on which the serial number has been removed, altered or otherwise
made illegible.
Products not purchased from an authorised Audio lab dealer.
Products that were not new at the time of original purchase.
Products sold ‘as is’, ‘as seen’ or ‘with faults’
Product not purchased from an Authorised Dealer/Distributor within the region
of the claim (ie parallel imports or grey market products)
Accidental damage or faults caused by commercial use, acts of God, incorrect
installation, incorrect connection, incorrect packaging, misuse or careless
operation or handling which is not in accordance with the user instructions.
Equipment that has been operated in conjunction with unsuitable, inappropriate
or faulty apparatus.
Repairs, alterations or modifications carried out by parties other than Audio
lab or its authorised service partners. Damage in transit that cannot be
attributable to the fault of Audio lab, the authorised distributor or dealer
(ie. claims otherwise covered by transit insurance.)
Faults relating to abnormal or inappropriate power supply voltage or power
surges. Faults relating to extremities in temperature, exposure to heat, water
or other liquids, insects, excessive moisture, sand, chemicals, battery
leakage or any other contaminants.
Any force majeure events, including but not limited to any acts of God, fire,
lightning, typhoon, storm, earthquake, hurricane, natural disaster, tsunami,
flood, war, riot, public disturbance.
Any other causes beyond the reasonable control of either Audio lab and its
Authorised Distributor.
Please note items purchased before 1st Jan 2021 are not eligible for the
extended warranty claim.
How to claim
To obtain warranty service please contact the authorised dealer from which you
purchased this product and present the limited warranty certificate offered
upon registration of your product’s extended warranty offer.
Do not dispatch goods without the prior agreement of the dealer distributor or
authorised service centre.
If asked to return products for inspection and or repair, please pack
carefully preferably in the original carton or packaging affording an equal
degree of protection and returned via insured, trackable courier service.
The authorised dealer or distributor will offer full return details and
instructions.
However, please note if unsuitable packaging is used the warranty may be
deemed void due to improper action in return.
Audiolab or the authorised distributor, dealer or service centre may make a
charge for the supply of new packaging for the return of the repaired item.
Please note, insurance is recommended as goods are returned at the owner’s
risk.
Authorised distributors or service centers cannot be held liable for loss or
damage in transit. insurance and freight charges on the return journey will be
paid for by Audio lab, authorised dealer, distributor or service centre if
corrective work proves to be necessary.
In the event of ‘no-fault found’ or ‘no repair necessary’, the return shipping
charge will be the responsibility of the owner.
Repairs
All repairs will be carried out by the appointed distributor (or locally
appointed service centre). Repairs handled or processed without authorization
or approval of the appointed representative will be excluded from this limited
warranty.
Please note, Audiolab is not able to supply parts or replacement items to any
other entity than the official distributor or authorised service centre.
Other than the warranty and services set out in this warranty, to the fullest
extent permitted by law, Audiolab shall not be liable to you and/or any third
party or entity whatsoever for:
- Any loss, damages and/or malfunction caused to any product(s) which is/are connected to any of the products covered by this warranty.
- Any damages, loss and liability, whether direct, indirect, incidental, consequential special, punitive or otherwise, howsoever caused by, arising out of or otherwise, in relation to the installation, delivery, use, service, repair, replacement and/or maintenance of the product;
- Any damages, loss and liability under this warranty in respect of any act, omission, or negligence of any of their technicians, employees, agents, representatives or independent contractors relating to the actual or purported performance of any of the obligations under this warranty.
Service Centre Address
Should a fault occur with your product, please pack it correctly using the
original packing, so you can ship it safely. For technical support, servicing
or product queries and information, please contact either your local retailer
or the office
below:
IAG Service Dept.
13/14 Glebe Road
Huntingdon
Cambridge shire
PE29 7DL
UK
Tel: +44(0)1480 452561
Email: service@audiolab.co.uk
For information on other authorised service centers worldwide contact Audio
lab
International, UK.
A worldwide distributors list is available on the Audiolab website:
www.audiolab.co.uk
Current disposal of this product. This marking indicates that this product
should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsible to promote the sustainable reuse of
material resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
https://qrco.de/audiolab-warranty
Audiolab IAG House,
13/14 Glebe Road, Huntingdon,
Cambridge shire, PE29 7DL, UK
Tel: +444(0)1 480 445256 1
Email: service@audiolab.co.uk
http://www.audiolab.co.uk
CODE: AH1 4-MNLOO0a
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>