CMS Electracom Blinky In Desk Unit Installation Guide

CMS Electracom Blinky In Desk Unit

Product usage instruction

1. Step 1 – Cut Out
   Cut a hole in the surface with a diameter of 135mm for surface thicknesses of 10mm – 40mm.

2. Step 2 – Insert / Fixing Housing
   Fold clamps into provision within the housing. Align housing in the cutout and insert housing into the desk. Screw the clamps so that they rotate out of the housing. Tighten screws until the assembly clamps down and is secure. The clamps will grip into the underside of the desk. Do not over-tighten – tighten by hand only.

3. Step 3 – Clip On Cover
   Align the top cover with the Blinky Unit. Push down and check that the cover fits flat and even to the surface.

4. Step 4 – Power Device
   Plug the unit into a power source.

Available Power Outlets
The diagram illustrates various configurations of power outlets available for the unit.

Note
No user-serviceable parts inside. If failure occurs or the supply cord is damaged, please contact CMS.

FAQ

• What should I do if the power unit fails or the cord is damaged?
  Contact CMS for assistance as there are no user-serviceable parts inside the unit.

• How tight should I secure the clamps during installation?
  The clamps should be tightened by hand only, without over tightening, to ensure the unit is secure.

• Can the unit be installed on any surface?
  The unit can be installed on surfaces with a thickness between 10mm and 40mm.

Installation instruction

STEP 1 – CUT OUT

Cut – Out Hole in surface 135mm diameter for surface thicknesses of 10mm – 40mm.

STEP 2 – INSERT / FIXING HOUSING

Fold clamps into provision within the housing. Align housing in the cutout and insert housing into the desk. Screw the clamps so that they rotate out of the housing. Tighten screws until the assembly clamps down and is secure. The clamps will grip the underside of the desk. DO NOT OVER-TIGHTEN – TIGHTEN BY HAND ONLY.

STEP 3 – CLIP-ON COVER

Align the top cover with the Blinky Unit  Push down and check that the cover fits flat and even to the surface.

STEP 4 – POWER DEVICE

Plug the unit into a power source, Available Power Outlets

Note:
No user-serviceable parts inside. If the failure occurs or the supply cord is damaged, please contact CMS Electracom

Specifications

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>