PLYCO MW-24124X24-5-12 Cupola Curb Framing Model User Guide
- June 16, 2024
- PLYCO
Table of Contents
PLYCO MW-24124X24-5-12 Cupola Curb Framing Model User Guide
CUPOLA MOUNTING BASE – ASSEMBLED KIT INCLUDES:
(1) ASSEMBLED MOUNTING BASE WITH ATTACHED FLASHING (16) #12-14 X 1″ HWH SELF- DRILLING CUPOLA ATTCHING SCREWS (PAINTED)
(8) 1/4-7 X 4″ HWH 5/16″ DRIVE TIMBERLOK STRUCTURAL SCREW FASTENERS (PAINTED) WITH BONDED WASHER
ROOF PANELS AND BASE FLASHINGS NOT SHOWN FOR CLARITY
RECOMMENDED FASTENERS – INCLUDED
MB-242 (2′) MIN. (6) 1/4-7 X 4″ HEX DRIVE TIMBERLOK PAINTED
MB-362 (3′) MIN. (6) 1/4-7 X 4″ HEX DRIVE TIMBERLOK – PAINTED
MB-482 (4′) MIN. (8) 1/4-7 X 4 HEX DRIVE TIMBERLOK PAINTED
INSTALLATION INSTRUCTIONS
- Position the assembled base over the roof sheathing and ridgecap. Fasteners will go thru at the ribs.
- PRE-DRILL 5/16″ HOLES-CENTER OVER EACH RIB ENSURING THAT THE FASTENER WILL GO INTO THE FRAMING 3.
- Anchor curb thru roof steel, then directly to building framing using fasteners per design drawings.
- Assembled base curb Includes painted self-drilling screws to attach cupola.
- Install cupola to the support curb box per instructions provided using #12-14×1″ self-drillers.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>