SNBTLA 9008 Satin Brass Front Door Handle Modern Entry Door Lock Set Instruction Manual

SNBTLA 9008 Satin Brass Front Door Handle Modern Entry Door Lock Set Instruction Manual

Parts Descriptions

UPPER BORE 2 1/8″ (54mm) DIAMETER HOLE
LOWER BORE 2 1/8″ (54mm) DIAMETER HOLE
AND 3/8″ (10mm) DIAMETER HOLE

1. MARK DOOR&BORE HOLES
   

2. INSTALL LATCH

3. PREPARE JAMB AND INSTALL STRIKE
   

4. INSTALL FUNITURE
   

INSTRUCTION FOR ADJUSTABLE LATCH

The cam is pushed fully to the right 70mm backset.
(During the adjustment, keeping two teeth of the cam to forward always.)

LATCH BACKSET ADJUSTMENT

Press the of the deabpil. Twist the faceplate pushing or pulling the backset into the desired length (either 2-3/4″/70mm or 2-3/8″/60mm).

To rotate the latch case as following illustration for backset 2-3/4″ (70mm). or reverse direction for 2-3/8″ (60mm)

Align notches on grip housing with proper grooves (2-3/8” or 2-3/4”) on latch. Slide on. At same time, align and linsert foot screw through pre-drilled hole.

Adjust to align with foot cap hole

Installations

1. MARK DOOR&BORE HOLES
   

2. INSTALL LATCH

3. PREPARE JAMB AND INSTALL STRIKE

4. INSTALL FUNITURE
   
   Entrance

INSTRUCTION FOR ADJUSTABLE LATCH

The cam is pushed fully to the right 70mm backset.
(During the adjustment, keeping two teeth of the cam to forward always.)

LATCH BACKSET ADJUSTMENT

Twist the faceplate pushing or pulling the backset into the desired Length (either 2-3/4″/70mm or 2-3/8″/60mm)

To rotate the latch case as following illustration for backset 2-3/4″ (70mm) or reverse direction for 2-3/8″ (60mm)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>