blinds2go BiFold ClickFIT Storm Grey Pleated Blind Installation Guide

June 13, 2024
blinds2go

Installation Guide
Click FIT Blinds

Bifold Click FIT Storm Grey Pleated Blind

Push the bracket firmly into place between the glass and the rubber seal.

Installing the brackets

blinds2go BiFold ClickFIT Storm Grey Pleated Blind -
feager

Place the brackets flat to the glass and push them in towards the frame, ensuring that they slide in under the rubber/mastic seal. Push in each bracket as far as possible, with one bracket in each corner of the glass.

Installing the blind

blinds2go BiFold ClickFIT Storm Grey Pleated Blind -
blindClip the headrail onto the brackets at the top of the window by aligning the rail with  he brackets and pushing the rail back towards the glass until you hear it click into place.
Hook the cord through the centre of the lower bracket on both sides of the window. The cord should be running straight down the edge of the glass, hooking around the bracket. Make sure it’s passing through the centre of the bracket and then straight across the bottom of the window.blinds2go BiFold
ClickFIT Storm Grey Pleated Blind - feager1To finish, clip the bottom rail into the lower brackets by aligning the rail with the brackets and pushing back firmly towards the glass, until the rail clicks into place.

Adjusting the tension

Over time the cords may slacken off and require re-tensioning. You’ll know if the blind needs re-tensioning as it will begin to slip back down of its own accord when raised.

blinds2go BiFold ClickFIT Storm Grey Pleated Blind -
tension

Start by removing the bottom rail – to do this, slide it upwards from one corner, to slide the bracket out from under the seal.blinds2go BiFold
ClickFIT Storm Grey Pleated Blind - tension1Then, remove the brackets from both ends of the rail and put the rail to one side.
Slot the brackets back into the corners, as per step 1 of this guide.blinds2go BiFold ClickFIT Storm Grey Pleated Blind - tension
2

At the bottom of the blind the cord is connected to both ends of a small spring. Untie the knot at one side of the spring.
Pull the end of the cord through by 5-10mm, then give the blind a test to see if the tension is right. Repeat this as necessary until the tension is correct.
Once you’re done, simply click the bottom rail back into place as per step 2 of this guide.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals