CMS Electracom ECBSN Echo Wireless Charging Module Installation Guide
- June 16, 2024
- CMS Electracom
Table of Contents
CMS Electracom ECBSN Echo Wireless Charging Module Installation Guide
Installation Instructions
STEP 1 – CUT OUT
Determine desired orientation of product and cut hole into desktop or joinery. The notch will be parallel to the GPO in horizontal position. REFFER TO DRAWING.
STEP 2 – INSERT UNIT INTO CUTOUT
Fold clamps into provision within housing.
Align dimple on housing with notch in the cut out and insert housing into
desk.
STEP 3 – TIGHTEN SCREWS
Screw through the plastic housing and clamps so that they rotate out of the
housing. Tighten screws until the assembly clamps down and is secure. The
clamps will grip into underside of desk.
DO NOT OVER TIGHTEN – TIGHTEN BY HAND ONLY
STEP 4 – CLIP ON COVER
Align guide and clips on the underside of the cover with provisions in
housing.
Secure the top cover and push down above where the clips are positioned.
STEP 5 – POWER DEVICE
Plug unit into power source.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>