MOUNT PLUS MB-W01 Medical Grade Monitor Wal Mount Instruction Manual
- June 16, 2024
- MOUNT PLUS
Table of Contents
MOUNT PLUS MB-W01 Medical Grade Monitor Wal Mount
SAFETY WARNING
- Use with products heavier than the rated weights indicated may result in instability causing possible injury.
- Mounts must be attached as specified in assembly instructions. Improper installation may result in damage or serious personal injury.
- Safety gear and proper tools must be used. This product should only be installed by professionals.
- This product is designed to be installed on wood stud walls, solid concrete walls, or brick walls.
- Do not shake the bracket.
- Do not pull the bracket hard.
- Do not hang items on the bracket.
Parts list
INSTALLATION
Wall Mount Assemble
- Remove the cover off the wallboard.
- Place the base on the wall and draw 4 holes’ positions, using a 12mm drill to punch 60mm deep holes.
- Install the arm on the base and adjust to proper rotation tightness.
Installation Monitors
Cable Management
- The internal threading length of the bracket is 1.85 meters, Please increase the length of the wire according to the actual situation.
- Install wall panel cover and round tube end cover.
Adjusting Load Bearing
Use H to adjust the load: Clockwise (+) to increase load bearing:
Counterclockwise (-) to reduce the load bearing.
Adjusting the Monitor Angle
Counterclockwise (-) the screw with G to adjust the angle. When fix the angle,
then clockwise (+) to tighten it.
DIMENSION
VESA Pattern: 75×75mm; 100×100mm
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>