Action Machine 1350 Machine One Piece Driveshaft User Guide
- June 16, 2024
- Action Machine
Table of Contents
Action Machine 1350 Machine One Piece Driveshaft User Guide
USE THIS GUIDE TO MEASURE YOUR DRIVESHAFT LENGTH ON YOUR ONE PIECE DRIVESHAFTS WITH A YOKE SHAFT.
Measure Instructions: It is important to measure the driveshaft length when the vehicle’s axle is in the normal riding position. The axle must be supported on safety stands – not hanging down.
TRANSFER CASE / TRANSMISSION DIFFERENTIAL
A DRIVESHAFT LENGTH:
Measure the rubber seal on the transfer case or transmission to the end yoke
or flange face on the differential.
B BOOT EXTRUSION LENGTH:
Measure the rubber seal on the transfer case or transmission to the end of the
boot.
Boot: Your transfer case or transmission should have a boot installed on it. If you are missing your boot consider adding replacement boot 40123472 (1410 Series) or 40021327 (3R Series) to your driveshaft order.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>