Munters DIV73WMS01 Sonata Dual Pulse Water Meter User Manual
- June 16, 2024
- Munters
Table of Contents
Munters DIV73WMS01 Sonata Dual Pulse Water Meter
Introduction
The Sonata is an advanced and highly accurate ultrasonic water meter for residential applications. The Sonata’s Dual Pulse output provides consumption values at a high resolution. Each of the two independent digital output channels can be configured to best match the data resolution required by the utility.
Features
- 2 Pulse Outputs
- Each Pulse Output can be set to forward/reverse
General Specifications
- Electronics & battery sealed
- Cable length: 1.3 meters/4.2 feet
- Environmental operation: min –20° to +60°C/-4°to +140°F
- Storage: min –20 °-70 +70 °C/-4°to +158°F
- Protection rating: IP68
- Life time= 12 Years*
- 1 liter or 0.1 liter per pulse (depending on the controller; refer to Controller Capabilities
Technical Specifications
- Outputs type Bi-Directional Solid State Relay
- On-Resistance max. 35 [Ω]
- Minimum pulse width 10 [msec]
- Load current (AC/DC) 120 [mA]
- Total power dissipation max. 800 [mW]
- Max voltage AC/DC 36 [V]
Installation Requirements
- Install the Meter in a horizontal position, dial face up.
- Flush the pipeline before installation.
- The meter should be constantly full of water.
Wiring
- Wiring depends on the water per pulse required.
- Red/Orange: 1 liter per pulse
- Black/Brown: 0.1 liter per pulse
- Do not connect the other two wires.
- Connect either wire to any input or any COM port.
Drawings are examples only. Any input or COM port can be used.
Controller Capabilities
Pulse Output| Trio| Rotem One/Pro Platinum Touch/Pro| Platinum Plus/XL|
AC-2000 3G
---|---|---|---|---
1.0
Liter/pulse| V| V| V| V
0.1
Liter/pulse| V| V| NA| NA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>