PINLOCK AGV Helmets Lens Installation Guide
- June 16, 2024
- PINLOCK
Table of Contents
Instruction manual
Pinlock® lens installation
How to install your Pinlock® lens
Your Pinlock® lens is made from moisture absorbing material. The Pinlock lens
fits exactly between the pins in the helmet visor and provides you a fog-free
vision.
The silicon seal on the Pinlock lens creates an insulating air pocket between
the Pinlock lens and the visor. The Pinlock® pins are excentric, which means
that the axis of the pin is not precisely in the center. This enables you to
increase or decrease the tension on the Pinlock lens by turning the pins,
allowing the silicone seal to have a perfect fit.
Remove the visor
Remove the helmet visor from the helmet as shown in the helmet manufacturers’ instructions.
Check the pin position
Check if the arrows on the Pinlock pins in the visor are pointing outwards. If not, please check the lens adjustment manual.
Install the lens
Then flex the helmet visor and place the Pinlock lens between the two pins provided in the helmet visor, avoid touching the lens surface. Place the silicon seal against the inside of the visor.
Check the seal
Carefully allow the helmet visor to reacquire its curved shape. Check with natural light if the silicon seal on the Pinlock lens makes full contact with the helmet visor. This is needed for to create the thermal barrier.
Not sealing correctly
If the silicon seal does not make full contact with the helmet visor, please check the lens adjustment manual.
Protective film
Remove the protective film from the Pinlock lens.
Reinstall the visor
Fit the helmet visor back on the helmet. Check if you can read the logo from the outside of the visor.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>