BRESSER 20X Stereo Microsope Instruction Manual

June 4, 2024
BRESSER

BRESSER logo 20X Stereo Microscope
Instruction Manual

BRESSER 20X Stereo MicrosopeBRESSER 20X Stereo
Microsope - icon

20X Stereo Microscope

BRESSER 20X Stereo Microsope - fig

General Warnings

  • Choking hazard — This product contains small parts that could be swallowed by children. This poses a choking hazard.
  • Risk of electric shock — This device contains electronic components that operate via a power source (power supply and/or batteries). Only use the device as described in the manual, otherwise, you run the risk of an electric shock.
  • Risk of fi re/explosion — Do not expose the device to high temperatures. Use only the recommended batteries. Do not short-circuit the device or batteries, or throw them into a fi re. Excessive heat or improper handling could trigger a short-circuit, a fi re or an explosion.
  • Risk of chemical burn — Make sure you insert the batteries correctly. Empty or damaged batteries could cause burns if they come into contact with the skin. If necessary, wear adequate gloves for protection.
  • Do not disassemble the device. In the event of a defect, please contact your dealer. The dealer will contact the Service Centre and can send the device in to be repaired, if necessary.
  • Tools with sharp edges are often used when working with this device. Because there is a risk of injury from such tools, store this device and all tools and accessories in a location that is out of the reach of children.

Parts overview

  1. Binocular view piece (with eyepiece supports)
  2. Stereo objective
  3. Eyepieces
  4. Illumination (LED)
  5. Microscope stage (with object plate)
  6. Stage clips
  7. Focus knob
  8. On/off switch ( illumination)
  9. Battery compartment
  10. Battery compartment clamp closure
  11. Mineral samples

Location
Before you start, choose an ideal location for using your microscope. It is important that you have enough light available, such as from a window or desk lamp.
Simple Observation
Place the object to be observed (for example, a rock) in the middle of the microscope stage (5). When possible, it is best to fi x the object to be observed in place with the stage clips (6).
Now, take a look through the binocular eye lens (1) and change the distance of the eyepiece (3) so that you see a circular, clear image.
Adjust the sharpness of the image by slowly turning the focus knob (7).
Illumination
To illuminate objects to be observed, remove both eyepieces (3) from the eyepiece supports (1) and turn the entire microscope over. In the base of the microscope, there is a battery compartment (9). Push the clamp closure (10) and open the battery compartment by pulling the cover open diagonally.
Place the batteries in the compartment so that the flat minus poles (-) press against the spring terminal and the plus poles (+) are touching the fl at contact sheets. Close the battery compartment with the cover and turn the microscope around again. Place the eyepieces back on. You can now turn on the light (4) with the on/off switch (8) on the base of the microscope.

Notes on Cleaning

  • Before cleaning the device, disconnect it from the power supply by removing the plug or batteries.
  • Only use a dry cloth to clean the exterior of the device. To avoid damaging the electronics, do not use any cleaning fluid.
  • Protect the device from dust and moisture.

The batteries should be removed from the unit if it has not been used for a long time.
EC Declaration of Conformity
** Bresser GmbH has issued a ‘Declaration of Conformity in accordance with applicable guidelines and corresponding standards. This can be viewed at any time upon request.
Disposal**
Dispose of the packaging materials properly, according to their type, such as paper or cardboard.
Contact your local waste-disposal service or environmental authority for information on the proper disposal.
Do not dispose of electronic devices in the household garbage!
As per Directive 2002/96/EC of the European Parliament on waste electrical and electronic equipment and its adaptation into German law, used electronic devices must be
collected separately and recycled in an environmentally friendly manner.
Empty, old batteries must be disposed of at battery collection points by the consumer.
You can find out more information about the disposal of devices or batteries produced after 6 January 2006 from your local waste disposal service or environmental authority.
In accordance with the regulations concerning batteries and rechargeable batteries, disposing of them in normal household waste is explicitly forbidden. Please make sure
to dispose of your used batteries as required by law — at a local collection point or in the retail market. The disposal of domestic waste violates the Battery Directive.
Batteries that contain toxins are marked with a sign and a chemical symbol.

  1. the battery contains cadmium
  2. battery contains mercury
  3. battery contains lead

Warranty and warranty term extension
The warranty term is two years from the date of purchase. Please keep your proof of purchase.
Register at www.bresser.de/warranty and fi ll out a brief questionnaire to get your warranty term extended to five years. Registration must be completed within three months of purchase (date of receipt) to validate the warranty. If you register thereafter, the warranty term will not be extended.
If you have problems with your device, please contact our customer service first. Do not send any products without consulting us first by telephone. Many problems with your device can be solved over the phone. If the problem cannot be resolved by phone, we will take care of transporting your device to be repaired. If the problem occurred after the warranty ended or it is not covered by our warranty terms, you will receive an estimate of repair costs, free of charge.
Service-Hotline: +49 (0) 2872 – 80 74-210

Important for any returns:

Please make sure to return the device carefully packed in the original packaging in order to prevent damage during transport. Also, please enclose your receipt for the device (or a copy) and a description of the defect. This warranty does not imply any restriction of your statutory rights.
Your dealer: ………………………………………………
Art. No.: …………………………………………………….
Description of problem: …………………………….
Name: ………………………………………………………..
Street: ………………………………………………………..
City/Postcode: ………………………………………….
Telephone: …………………………………………………
Date of purchase: ……………………………………….
Signature: ……………………………………………………

National Geographic’s net proceeds support vital exploration, conservation, research, and education programs.
Visit our website: www.nationalgeographic.com
© 2013 National Geographic Society
NATIONAL GEOGRAPHIC and Yellow Border Design are trademarks of the National Geographic Society, used under license. All rights reserved.

Bresser GmbH
Gutenbergstr. 2
DE-46414 Rhede
www.bresser.de
info@bresser.dehttps://tm.by

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

BRESSER User Manuals

Related Manuals