Honeywell Silent Knight EVS-SW24 Switch Expander Instruction Manual
- June 16, 2024
- Honeywell Silent Knight
Table of Contents
Honeywell Silent Knight EVS-SW24 Switch Expander Instruction Manual
1. Description
The EVS-SW24 adds 24 additional switches to the EVS Series controls providing a total of 40 switches (with the EVS-VCM or EVS-RVM).
NOTE: Installation and wiring of this device must be done in accordance with NFPA 72 and local ordinances.
1.1 Compatibility
The EVS-SW24 is compatible with the following Silent Knight Series fire alarm
control panels (FACPs):
- 6820EVS
- 5820XL-EVS
1.2 Specifications
- Standby Current: 10mA
- Alarm Current: 25mA
2 Mounting
- Open the cabinet door and the dead front panel.
- Remove AC power from the main control panel.
- Disconnect the backup batteries.
- Install the EVS-SW24 on the mounting studs located on the inside of the dead front panel on the FACP. Refer to Figure 1.
- Secure the switch expander to the dead front panel using the supplied 0.25” hex nuts.
Figure 1 EVS-SW24 Mounting Locations
3. Wiring
1. Connect one end of the supplied wiring harness (PN 130398) to the EVS-VCM or EVS-RVM. Then, connect the other end of the wiring harness to the EVS-SW24 as shown below.
Figure 2 Connection for EVS-VCM to EVS-SW24
2. Restore AC power.
3. Reconnect the backup batteries.
Honeywell Silent Knight
12 Clintonville Road
Northford, CT 06472-1610
203.484.7161
www.silentknight.com
LS10066-001SK-E | C | 12/21
©2021 Honeywell International Inc.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>