FINDOOR RADIOEM204 Radio Rolling Code Transmitters Instructions

FINDOOR RADIOEM204 Radio Rolling Code Transmitters Instructions

Transmitter Programming: RADIOEM204

The EM204 Transmitter can be used as either a 1-Door x 4-Button Transmitter or as a Multiple-Door Transmitter. The
Transmitter can be re-programmed as needs change. Replacement Battery: 1x CR2032 (3V).

Matching the Transmitter to the On-Board Radio Receiver: RADIORE200

Once the Transmitter has been correctly programmed, follow the steps below:

1. HOLD the Receiver’s LEARN button until the LED BLINKS -, for approx. 2 sec. (frequency of 1 sec. ON / 1 sec. OFF).a) To program in 4-Button Mode: On the Transmitter, HOLD any button until the Receiver’s LED stopsblinking £ .
   b) To program in 4 x 1-Button Mode: On the Transmitter, HOLD the desired button that you want programmeduntil the Receiver’s LED stops blinking {

Note: One (1) Receiver will accept up to fifty (50) Transmitters.

Deleting ALL Transmitters from the Receiver’s Memory:

1. HOLD the Receiver’s LEARN button until the LED BLINKS for approx. 10 sec. (frequency of 1/3 sec. ON/
1/3 sec. OFF).

Product Specification:

1.  Input Rating: DC 3V 20mA
2. Operating Temperature: -10 ~ 40°C\

Instructional safeguard:

This product contains a coin / button cell battery. If the cell / button cell battery is swallowed. It can
cause severe internal burns in just 2 hours and can lead to death.

FCC and ISED

This device complies with Part 15 of the FCC Rules and Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause harmul interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
WARNING:Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and Industry Canada ICES standards.
These limits are designed to provide reasonable protection against harmful interference in a residential installation .
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by tuming the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio/TV technician for help.
1-866-338-8308 findoor.ca

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>