ATAG WS62–RCL Evolve Cooker Hood Instructions

ATAG WS62–RCL Evolve Cooker Hood

Introduction

• You have selected an ATAG extractor hood.
• Optimum ease of use and simple operation were the most important factors in the development of this product.
• The extractor hood operates silently and provides maximum extraction effect. This banishes cooking smells complete.
• The WS62../WS92..RCL is specially designed for use on a central extraction system and is fitted with an electric flap.
• This manual describes how you can make the best possible use of your extractor hood. You can find information in it about the controls and background information about how the appliance works. You will also find tips about how to look after it.
• The safety instructions that are important during the installation are included in the installation guide, which is supplied separately and is meant for the installer.
• Please keep this manual carefully, since any subsequent user will also find it very useful.

Please read the separate safety instructions prior to use

You can find the most recent version of the instructions for use on our website.

Controls

Switch hood on/off

• Press the on/off button A.
• The electric flap is opened.
• After switching on, wait at least 10 seconds before switching the hood back off.
• Press the A button again.
• The electric flap is closed.
• After switching off, wait at least 10 seconds before switching the hood back on.

Switch lighting on/off

• Press the lighting button (B).
• The lighting comes on.
• Press the B button again.
• The lighting goes off.

Cleaning

Attention:  Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally. Do not use abrasive products. Do not use alcohol!

Attention: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. Therefore, we recommend serving these instructions. The manufacturer declines all responsibility for any damage to the hood or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations.

Cooker hood

Clean the cooker hood with soapy water and a soft cloth. Then wipe with clean water to rinse. Do not use aggressive cleaning agents such as soda. The cooker hood paintwork will stay looking nice if you wax it occasionally.

Stainless steel canopy hoods

Do not use any sort of scourer. Treat with a stainless steel care product and polish with the structure of the stainless steel.

Metal grease filters

These must be cleaned once a month (or when the filter saturation indication system – if envisaged on the model in possession – indicates this necessity) using nonaggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. The openings must be placed downwards to let the water run out of the filters. The cleaning agents will make the aluminum filter turn dull, this is normal.

Grease filters

Removing the grease filters

Switch off the electricity! Remove the plug from the socket or switch the electricity off at the mains. Pull the grease filter towards you and tilt it downwards at the front.

Lighting

Attention: This hood is fitted with an LED light! These have to be replaced by a authorized technician. Do not attempt to replace the LED light by yourself.

What should I do if…

If the appliance does not work properly, this does not always mean that it is defective. Try to deal with the problem yourself first. Phone the service department if the advice given below does not work.

Attention: Disconnect the appliance from the mains before starting the repair, preferably by removing the plug from the socket or setting the main switch to zero.

Faults table

department.
Extractor hood makes a noise.| Discharge too long or too many bends in the duct.

__

Flap defective.

| Change the discharge ducting (see installation guide).

__

Phone the service department.

No extraction.| Flap or control defective.

__

The connection cable is defective.

| Phone the service department.

General

This appliance should be connected to the power supply by a recognized fitter who is familiar with and works according to the correct safety regulations. This appliance meets European requirements.

Important that you know

• The minimum distance between the supporting surface for the cooking vessels on the gas hob and the lowest part of the range hood must be not less than 65 cm. For use with electric, ceramic or induction hob, this distance must be at least 55 cm.
• The discharge may only be connected to a central mechanical extraction.
• Consider local regulations with respect to the ventilation of gas appliances.
• The shorter the duct, and the fewer the bends in it, the better the cooker hood will work.
• Before you start drilling check that there are no installation cables present.
• The connecting pipe for the cooker hood has a diameter of 125 mm. It is best also to use a flue pipe of the same diameter.
• The installation material supplied with this range hood is designed for fixing to reinforced concrete or masonry walls. For some types of walls, you may need special plugs and screws.

Connection

Electric connection

The appliance has been manufactured as a class II, therefore no earth cable is necessary. Make sure the supply voltage ratings correspond with those stated on the appliance data plate. The connection to the mains is carried out as follows:

• BROWN = phase L
• BLUE = phase N

This canopy hood has been provided with a power plug. When installing the hood, make sure that this plug remains accessible. We recommend installing the wall socket out of view, behind the chimney cover.

Attention: If you want to make a fixed connection, ensure that a multi- pole switch with a distance between contacts of 3 mm is installed in the supply cable.

Mounting

• Mount the hood on the wall using the plugs and screws provided in bracket (A). Check size specifications.

• Adjust the width of the brackets to the width of the upper chimney. Next, mount the bracket on the wall using the plugs and the screws (B). Take into account the distance between the bracket and the ceiling (Check size specifications).

• Install the vent duct on the flange (C)and then onto the connecting surface of the exhaust grid.

• Put the plug in the wall socket.

• Slide the upper chimney into the lower chimney.

• Attach the lower chimney to the hood using the screws provided (D).

• Slide the upper chimney around the bracket and attach with the screws provided (E).

Disposal of the appliance and packaging

This product is made from sustainable materials. However, the appliance must be disposed of responsibly at the end of its useful life. The government can provide you with information about this. The appliance packaging can be recycled. The following materials have been used:

• cardboard;
• polyethylene foil (PE);
• CFC-free polystyrene (hard PS foam).

Dispose of these materials responsibly in accordance with legal provisions.

The product has a pictogram of a crossed-out waste container. This indicates that household appliances must be disposed of separately. This means that the appliance may not be processed via the regular \waste flow at the end of its useful life. You should take it to a special municipal waste depot or a sales outlet that offers to do this for you. Collecting household equipment separately prevents harm to the environment and public health. The materials used in manufacturing this appliance can be recycled, which provides considerable savings in energy and raw materials.

Declaration of conformity

We hereby declare that our products comply with the relevant European directives, standards and regulations as well as all requirements referred to in the standards.

www.atag.nl

www.atag.be

References

• Premium keukenapparatuur | Nederlands Design | ATAG
• Premium keukenapparatuur | Nederlands Design | ATAG

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>