NEXTIVITY SHIELD MegaFi High Power User Equipment User Guide
- June 15, 2024
- NEXTIVITY
Table of Contents
NEXTIVITY SHIELD MegaFi High Power User Equipment User Guide
Included in the Box
- High Power MegaFi Router
- Antennas mounted on top cover (3x cellular, 2x Wi-Fi, and 1x GPS connections)
- Battery
- Fan
- Power Adapter
- Quick Start Guide
The SHIELD MegaFi High Power User Equipment (HPUE) paired with a specially designed Band 14 antenna puts everything in one case for the maximum high power user equipment experience. For set up, follow these steps.
Prerequisites
Ensure you or the distributor sending you the MegaGo have done the following:
- Activated the FirstNet SIM, which is included in the MegaGo
- Made note of the pertinent numbers located on the inside case panel (IMEI, Serial Number, SSID/Password, etc.)
Power Up
Before powering on, open the vent and fan caps on the sides of the unit. To power on, press and hold the power button located in the bottom left corner until the LED indicator lights up green. Wait for the unit to fully power up, which, in most instances will occur within three minutes.
Connect to Wi-Fi
The factory generated Wi-Fi SSID, authentication mode, and password are provided on the label inside the case. You can also scan the QR code on the label to automatically connect to Wi-Fi. The SSID will be present within three minutes of power up as noted above.
Note: It is possible to “hide” the SSID in the configuration, so if you have hidden your SSID, it will not be available. If this occurs and you cannot access the router Wi-Fi, then you will need to plug into the Ethernet port on the side of the case to access the router IP address as provided (or reset by you), or open the case and reset MegaFi using the reset button located in the front of the MegaFi unit.
In Use
Be sure the lid to the case is closed. This will generally provide the best connectivity, as the antenna in the case lid is designed to operate with the lid closed. Once the unit is operating and the lid is closed, please set “face up” as indicated on the outside of the case.
Power Recharge
To recharge the case, remove the power cord from the slot inside the case and
plug it into the DC power port located on the left side of the case.
Turn the power off before charging. If you need further help, please see more
information at https://nextivityinc.com/shield-megago/
For more information scan the QR code or contact Customer Support at
support@nextivityinc.com
16550 West Bernardo Drive, Bldg. 5, Suite 550 | San Diego, CA 92127 |
www.nextivityinc.com
Copyright © 2023 by Nextivity, Inc, U.S. All rights reserved. The Nextivity
logo is a registered trademark of Nextivity Inc. All other trademarks or
registered trademarks listed belong to their respective owners. Rev23-1214
References
- Nextivity - Smart Signal Boosters for Cellular, Critical Comms, HPUE, and Private LTE
- SHIELD MegaGo HPUE - Nextivity
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>