OWLTRA TST-217 in Outdoor Safe Tunnel Snap Mouse Trap 2PCS User Manual

June 15, 2024
OWLTRA

OWLTRA TST-217 in Outdoor Safe Tunnel Snap Mouse Trap 2PCS User Manual

FAQ

Q1: How do I dispose of the dead rodent?

Tum the switch to OFF and remove batteries. Pull and remove the top of the trap, then property discard the rodent in an outdoor trash bin.

Q2: How do I replace the batteries?

A: Turn the switch to OFF and insert 4 AA alkaline batteries into the compartment.

Q3: What type of batteries does the trap need?

Q4: The green light keeps flashing, but it doesn't catch any rodents. What

do I do?

A: Try resetting the device. Just turn off the switch, re-set the trap again by following How To Set Up steps 1-5.

Q5: How do I tell if the trap has been activated?

A: Turn the switch to the ON position. The light will flash green for one second to indicate that it has been activated.

Q6: What if the trap is in the attic? Does it make a sound to indicate that

something has been caught?

This trap is designed with a LED light to notify you of a catch. A blinking green light in 10-second intervals means a rodent has been caught. We recommend checking the trap frequently.

Q7: How many volts does this deliver? Is it enough to kill large rats?

Owitra Mouse Traps provide a shock of about 5000-8000 volts for 90 seconds. To exterminate large rodents, we recommend using our Owitra Rat Traps which generate 6000-9000 volts for 150 seconds.

Q8: Does the trap come with batteries?

A: Batteries are not included.

Q9: Can I use this outside?

A: No, it is not weatherproof. But you could use it in any area shielded from water.

Q10: What baits should I use in the traps?

A: Peanut butter, chocolate, gumdrops, soft cheese, nuts, and oats work best.

Q11: How much bait should I use in the traps?

A: A small pea-sized amount should be placed in the bait area inside the trap.

Q12: How do I safely clean the trap?

A: Refer to the cleaning instructions in the manual.

Q13: Where should I place the trap?

A: Place the trap on a clean, dry surface along a wall near signs of rodent activity.

Q14: Trap keeps flashing green and red constantly. Nothing in it. What's

going on with it?

Normally after turn on the switch, the trap will self-check and flush green once to indicate it is activated and in standby mode. Then if your trap blink fast both green and red at the same time. Means that self-checking find problem. Please check the trap as below two steps: 1. Please remove the top and bottom and check the 4 sensor posts as in the picture. Check if the too big bait or other thing had covered on the sensor. Then clean the four posts, make sure no any dirty to cover the sensor system. 2. Then also check the bottom zapping plate, make sure the plate is totally dry. No water or moisture on or inside the matel plate. 3. After that, assembly and tun on the trap again to find if it is ok to work.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  1. Reorient or relocate the receiving antenna.

  2. Increase the separation between the equipment and receiver.

  3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

  4. Consult the dealer or an experienced radio/TV technician for help.

  5. Battery Cover

  6. Electric (Chamber) Top

  7. Power Switch

  8. Two LED Light

  9. Magnetic Buckle

  10. Bait Area

  11. Bottom Chamber

  12. Entrance

  13. Infrared Sensors

HOW TO SET UP

  1. Before adding bait, turn the switch to the OFF (“0”) position. [photo 1]

  2. Pull and remove the top chamber. Use only a pea-sized amount of peanut butter (or other foods that attract rodents) in the bait area. DO NOT let the bait touch the metal plate surfaces or the sensor detectors, as it may cause a malfunction. [photo 2]

  3. Attach the top chamber back into place. Insert 4 “AA” batteries and turn the switch to the ON (“I”) position, The green light will flash to indicate the trap has been activated.

  4. Place the trap on a clean, dry surface along a wall. Position the trap so that the entrance is facing away from the wall. [photo 3]

  5. Once a rodent is caught, the green light will flash at 10-second intervals.

  6. A flashing red light indicates low battery life.

  7. Rodent Disposal: Turn the switch to OFF (“0”) and remove the batteries. Pull and remove the top chamber and properly discard the rodent. [photo 4] Follow the cleaning instructions on the trap or in the manual.

HOW TO CLEAN

  1. Turn the switch OFF (“0”) and remove the batteries. Pull and remove the top chamber. [photo C1]
  2. Clean: Use warm water or hydrogen peroxide topical solution and a soft-bristle brush to clean the chamber. DO NOT get any water on the electronic top. [photo C2]

BATTERIES: Use 4 AA alkaline batteries. Insert and remove batteries as indicated in the instructions. Rechargeable batteries should be removed from the device before charging. Different types of batteries-new or used-should not be mixed, as it may reduce performance or damage the device. Batteries should be inserted with the correct polarity as indicated in the battery compartment. Exhausted batteries should be removed from the trap and safely disposed of. Remove the batteries if the trap will be stored unused for a long period. The supply terminals are not to be short-circuited,

This device complies with part of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this device not expressly approved by Owitra could void the user’s authority to operate the equipment.

Statement applies only to European countries. (CE): This appliance can be used by children aged eight years and above. It can also be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction conceming use of the appliance in a safe way and understand the hazards involved.

Use Owitra only on dry, clean indoor surfaces. Keep away from flammable vapors, liquids, or combustible solids. DO NOT use in barns, stables, or similar wet or dusty locations. High Voltage: Keep out of reach of children and pets. Handle the trap only by dry hands or rubber gloves. Turn the power OFF when baiting or touching the metal plates and remove the batteries if necessary.

HIGH VOLTAGE: Keep out of reach of children and pets. Handle the trap only by dry hands or rubber gloves. Turn the power OFF when baiting or touching the metal plates and remove the batteries if necessary.

ELECTROMAGNETIC WAVES: This device emits electromagnetic waves. Individuals with heart conditions or similar ailments should be very careful when using this product. Keep pacemaker sand life support devices at least one foot away. If you receive a shock, please consult your cardiologist. Failure to read and heed all warnings and directions may cause electric shock, fire, or serious injury. Please read and follow all label instructions.

WARNING: This product may expose you to lead or lead compounds which may cause cancer, birth defects or other regenerative damage under CA’s terms. See www.P65Warnings.ca.gov for more details.

The trap with dual-infrared sensor design. Protects children and pets from accidentally triggering the trap. Generates high-voltage shock when rodents enter the trap for 100% extermination. Quick. Humane. Safe.

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

OWLTRA User Manuals

Related Manuals