OWLTRA EMZ30 Indoor Electric Mouse Trap User Manual
- June 15, 2024
- OWLTRA
Table of Contents
USER MANUAL
FOR MOUSE TRAP
The trap with dual-infrared sensor design. Protects children and pets from accidentally triggering the trap. Generates high-voltage shock when rodents enter the trap for 100% extermination. Quick. Humane. Safe.
FAQ
Owiltra Family
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consultthe dealer or an experienced radio/TV technician for help.
-
Battery Cover
-
Electric (Chamber) Top
-
Power Switch
-
Two LED Light
-
Magnetic Buckle
-
Bait Area
-
Bottom Chamber
-
Entrance
-
Infrared Sensors
HOW TO SET UP
- Before adding bait, turn the switch to the OFF ( “0″ ) position. [photo 1] OF N
- Pull and remove the top chamber. Use only a pea-sized amount of peanut butter (or other foods that attract rodents) in the bait area. DO NOT let the bait touch the metal plate surfaces or the sensor detectors, as it may cause a malfunction. [photo 2]
- Attach the top chamber backiinto place. Insert4 “AA” batteriesand turn the switch tothe ON( “I” ) position. The green light will flash to indicate the trap has been activated.
- Place the trap on a clean, dry surface along a wall. Position the trap so that the entrance isfacing away from the wall. [photo 3]
- 0nce a rodentis caught, the green light wil flash at 10-second intervals.
- Aflashing red light indicates low battery life.
- Rodent Disposal: Tur the switch to OFF ( “0″ ) and removethe batteries. Pull and remove the top chamber and properly discard the rodent. [photo 4] Follow the cleaning instructions on the trap of in the manual.
How To Clen
- Tum the switch OFF (“0”) and remove the batteries [photo C1]. Pull and remove the top chamber.
- Clean: Use warm water or hydrogen peroxide topical solution and a soft-bristle brush to clean the chamber. DO NOT get any water on the electronic top. [photo C2]
- Dry: Air dry the interior and exterior chamber completely. Dry hands thoroughly.if the bottom housing is not completely dry, the trap may flash both green and red, and the trap will not work properly.
- Reassemble: Attach the top back into place.
- Reset the trap following the HOW TO SET UP steps 1-4
BATTERIES : Use 4 AA alkaline batteries. Insert and remove batteries as
indicated in the instructions. Rechargeable batteries should be removed from
the device before charging. Different types of batteries— new or used—should
ot be mixed, as it may reduce performance or damage the device. Batteries
should be inserted with the correct polarity as indicated in the battery
compartment. Exhausted batteries should be removed from the trap and safely
disposed of. Remove the batteries if the trap will be stored unused for a long
period. The supply terminals are not to be short-circuited.
This device complies with part of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
WARNING: Changes or modifications to this device not expressly approved
by Owitra could void the user’s authority to operate the equipment. Statement
applies only to European countries. (CE): This appliance can be used by
children aged eight yearsand above. It can also be used by persons with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved.
Use Owltra only on dry, clean indoor surfaces. Keep away from flammable
vapors, liquids, or combustible solids. DO NOT use in barns, stables, or
similar wet or dusty locations. High Voltage: Keep out of reach of children
and pets. Handle the trap only by dry hands or rubber gloves. Turn the power
OFF when baiting or touching the metal plates and remove the batteries if
necessary.
HIGH VOLTAGE: Keep out of reach of children and pets. Handle the trap
only by dry hands or rubber gloves. Turn the power OFF when baiting or
touching the metal plates and remove the batteries if necessary.
ELECTROMAGNETIC WAVES: This device emits electromagnetic waves.
Individuals with heart conditions or similar ailments should be very careful
when using this product. Keep pacemaker sand life support devices at least one
foot away. If you receive a shock, please consult your cardiologist. Failure
to read and heed all warnings and directions may cause electric shock, fire,
or serious injury. Please read and follow all label instructions.
WARNING: This product may expose you to lead or lead compounds which may
cause cancer, birth defects or other regenerative damage under CA’s terms. See
www.P65Warnings.ca.gov for more details.
‘SAVE THE USER MANUAL
For technical support and other services, please email:
Selvice@hiowltra.com
Owitra Tech Co.Ltd
Electronic Mouse Trap Model No: EMZ30
US Pat 11464222, EU Pat 3732961
and other pending patents
EPA Est.No:95649-CHN-1
www.hiowitra.com
Designed in USA
Made in China
dd: 20230412
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>