SZLFKJ 101 3 In 1 Air Conditioners Evaporative Air Cooler Instruction Manual
- June 15, 2024
- SZLFKJ
Table of Contents
SZLFKJ 101 3 In 1 Air Conditioners Evaporative Air Cooler Instruction
Manual
Product Structure
Technical Parameters
Model| Rated power supply| Rated power || Noise value| “Maximum water
injection| Notes
---|---|---|---|---|---
101| TI0V-60Fz| 65w| 60dB| 10L| Mecharies
102| 110V-60Hz| 65W| <60dB| 10L| Remote control
Functional Features
Cold air humidification principle: the cold water in the water tank is pumped to the top of the machine body by the water pump, and then flows down through the wet curtain paper, and then the cold air with certain humidity around the wet curtain paper is blown out by the rotating wind wheel; because the water absorbs heat when evaporating, so as to achieve the function of reducing temperature and increasing humidification.
Electrical Schematic Diagram
Product structure and function are subject to change without prior notice)
Assembly and Water Addition Method
-
Open the packing box, take out the cooling fan, and place it on the horizontal ground; check the parts in the packing box whether they are consistent with the packing list in the manual
Note: the ice crystal box is placed in the foam inside the carton. -
Installation of universal wheel: place the cooling fan on the horizontal ground, take out the Mexican wheels installed in the upper foam, and install the Mexican wheels.
Using Method
How to use remote control
-
On / off button: the cooling fan is in standby mode after the power s plugged in, and the buzzer sounds “Bi”. Press this button to turn on the cooling fan. The cooling fan starts at medium speed, and then turns to low speed. Press this button to turn off the cooling fan.
-
Wind direction (swing wind) button: press this button, the wind direction can swing left and right automatically, and then press this button to cancel the function; manually swing the page horizontally, the wind direction can be selected up and down manually.
-
Timing button: in the working state of the cold fan, press this button to enter the timing state. At this time, set the timing time as 1 hours, and the timing time can be selected within 1 ~7 hours, When the timer is 7.5 hours, press this button again to cancel the timer function ‘The timing is switched according to the following figure
-
Cold air (humidification) button: when the cold air (humidification) gear is sclected, the cold air
humidification function will be started. At this time, if the frozen ice crystal box or ice cubes are
added to the water tank, the air‘minutes. outlet temperature can be reduced by about 3C after a few -
Wind speed button: press this button continuously, the wind speed will be switched in the following ways, and the corresponding indicator light will be displayed.
Mechanical using method
a. Select the speed control switch to start and stop the cooling fan and
select the wind speed
O-stop 1-low speed 2-medium speed 3- high speed
KHow to use ice erystal box
Iee crystal box has unique features of cold storage and heat preservation,
which can slowly absorb, the heat in the water, make the water temperature in
the water tank lower than the ambient temperature, and make the wind from the
cold fan cooler.
Using method:
a. Put the ice crystal box directly into the freezer until it freezes
completely.
b. Put the frozen ice crystal box into the upper water tank.
c. This machine is equipped with two ice crystal boxes, which can ensure
continuous circulation
Notes
-
This product should be used according to the rated voltage.
-
Non-professional repair personnel are not allowed to repair or modify the machine by themselves.
-
Do not operate with wet hands so as to avoid electric shock
-
In order to avoid danger, if the power cord is damaged, it must be replaced by the full-time personnel of the manufacturer, its maintenance department or similar departments.
-
please pull out the power plug when do not use the machine for a long time or clean and mave the machine.
-
In order to prevent accidental injury or damage to the machine, please do not insert foreign matters at the air inlet and outlet.
-
Do not use the machine outdoors; i s strictly forbidden to use the machine in the environment with flammable and explosive gases, and avoid direct sunlight for a long time.
-
Do not place the machine in an inclined or other uneven place.
-
The water level of the water tank shall not exceed the “MAX” indication scale at any time, When the cooling air / humidification is turned on, the total water level of the water tank shall not be lower than the “MIN” indication scale.
-
Do not tilt or collide when placing or moving the machine after adding water into the water tank.
Please push it slowly from the side to avoid water overflow when moving the machine -
It is forbidden to overturn the machine to prevent accidents. If the machine dumps and there is water in the machine, the power plug should be removed immediately and sent to the ‘maintenance department or afire-sales service office for maintenance.
-
Do not place objects on the machine. Do not cover the air inlet and outlet
-
When cleaning the surface of the machine, wipe it with wet cloth (or add a small amount of cleaning agent). Do not use corrosive cleaning agent or similar solvent. Do not wash the ‘machine with water.
-
Do not put the air inlet and outlet of the machine close to the wall, curtain and other objects, so as to avoid danger or damage to the machine.
-
Do not knock or vibrate the machine body when using, otherwise it may cause automatic shutdown.(remote only)
-
In summer, the water in the water tank is easy to deteriorate and produce peculiar smell. Please pay attention to change the water.
-
Product maintenance must be carried out at the maintenance point designated by the company.
-
It is normal that there is a lttle peculiar smell when the machine is used for the first two times. ‘This peculiar smell is the smell emitted by the new wet curtain paper when it just contacts with water.
-
Please pull out the plug when filling in water and cleaning,
-
Make sure the fan is disconnected from the power supply before removing the protective shell.
Cleaning and Maintenance
-
Cleaning wet curtain paper Pull out the power plug, remove the air filter screen first, and then take out the wet curtain paper from the machine. Afier brushing the wet curtain paper with neutral detergent and soft brush, rinse it with clean water, and then put it back on the machine.
Note: wet curtain paper should be insialled smoothly to avoid water leakage. -
Cleaning water tank Pull out the power plug, the fixed and immovable water tank can not be pulled out for cleaning. When cleaning, clean tap water can be used for many times, and clean tap water should be used during using period.
-
Clean the shell Clean with neutral detergent and soft cloth.
Warning: due to the high voltage inside the machine, the power plug must be pulled out during cleaning, and the power is cut off for operation.No part of the control panel should be stained with water.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>