Sg ECOLINE IP20 Hanging Light User Guide
- June 15, 2024
- sg
Table of Contents
Sg ECOLINE IP20 Hanging Light
Product Information
Specifications
- Dimensions: 29mm x 96mm x 166mm
- Product Line: EcoLine
- Power Supply: 220-240V, 50/60Hz
- IP Rating: IP20
- Length: 1160mm
- Number of LEDs: 5
- LED Diameter: 47mm
- DALI Compatibility: Yes
- Maximum Current: 16 A
- Mounting Holes Diameter: 8mm x 12mm
- Wiring: N3 N L 11 22
Product Usage Instructions
Installation
Please follow these steps to install the product:
- Make sure the power supply is switched off.
- Select a suitable location for installation.
- Securely mount the product using the provided mounting holes.
- Connect the wiring following the provided wiring diagram (N3 N L 11 22).
- If DALI compatibility is required, connect the DALI wiring accordingly.
- If replacing the light source or control gear, please refer to the relevant sections below.
Light Source Replacement:
If the light source needs to be replaced, please follow these steps:
- Ensure the power supply is switched off.
- If DALI compatibility is enabled, make sure the DALI connection is disconnected.
- Remove the existing light source by gently pulling it out.
- Insert the new light source into the socket, ensuring a secure fit.
- If DALI compatibility is required, reconnect the DALI wiring accordingly.
- Switch on the power supply and test the new light source.
Control Gear Replacement:
If the control gear needs to be replaced, please follow these steps:
- Ensure the power supply is switched off.
- If DALI compatibility is enabled, make sure the DALI connection is disconnected.
- Locate the control gear compartment on the product.
- Open the compartment using the provided access mechanism (e.g., screws, latches).
- Remove the existing control gear and disconnect any wiring connections.
- Install the new control gear, ensuring proper wiring connections.
- If DALI compatibility is required, reconnect the DALI wiring accordingly.
- Close the control gear compartment securely.
- Switch on the power supply and test the product.
Frequently Asked Questions (FAQ)
Q: Can I install and maintain the product myself?
A: The product should only be installed and maintained by a registered installation company (NO) or an authorized electrician (EN).
Q: Is the light source replaceable?
A: Yes, the light source can be replaced. Please refer to the “Light Source Replacement” section for detailed instructions.
Q: Is the control gear replaceable?
A: Yes, the control gear can be replaced. Please refer to the “Control Gear Replacement” section for detailed instructions.
Q: How should I connect the DALI wiring?
A: If DALI compatibility is required, please follow the provided wiring diagram and connect the DALI wiring accordingly.
220-240V, 50/60Hz
DIMENSION
INSTALLATION
Replaceable (LED only) light source by a professional
Replaceable control gear by a professional
Only to be installed and maintained by an authorized electrician.
Turn off power before installing.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>