Diosmio B09SB1KMPK Security Lock Box User Manual

Table of Contents

Diosmio B09SB1KMPK Security Lock Box

Diosmio B09SB1KMPK Security Lock Box

Please read the following instructions carefully and use the product correctly.
Please retain this manual for future reference. If you pass the product to someone else, please also hand over this manual.

A. To securely mount the safe, use at least 2 wall anchors.
B. To open the safe for the first time, please use the emergency key and master key provided. Please note that these keys are not inside the safe, but are provided in a separate bag.
C. We highly recommend that you set a new code after opening the safe for the first time.
We highly recommend setting a new code after opening the safe for the first time.

A. After opening the safe, please install 4 AAA batteries and confirm that it is working.
B. Set a new password. The default password is “159.”

NOTE:

When opening the safe for the first time, remove the battery cover on the right.
Insert the emergency key into the lock hole.
Turn the key to the left and then rotate the knob to the right to open the door.
Ensure that the key is outside the safe before closing the door.

A. To remove the cover, Slide it to the right.

Initial Setup

B. Insert the key into the lock hole, turn it to the left, and ensure the convex side is up.

Initial Setup

C. Turn the knob to the right to open the door.

Initial Setup

A. Install 4 AAA (1.5V) batteries in the battery compartment.

Setting the Code

B. Set or change the master code:

Press the “0” button twice while the door is open.
Press the reset button on the back of the left side of the door. The yellow light will turn on.
Enter a 3-digit code from 1 to 8 you want and press “#” to confirm.
Two beeps indicate that the new code has been accepted and stored.

C. Set or change the personal code:

To reset the device, open the door and press the reset button located on the back side left of the door and the yellow light to turn on.
Enter a 3-digit code from 1 to 8 you want and press “#” to confirm.
Two beeps indicate that the new code has been accepted and stored.

There are two ways to open the safe box:

A. Enter the personal or master code and press the confirm button “#”. The buzzer will beep three times, and the green indicator light will turn on, indicating the correct code. Turn the knob to the right to open the door.
B. Open the safe directly with the emergency key.

Close the door and turn the knob counterclockwise.

Please Note:

If you input the wrong code, press the cancel button “*” to clear all numbers and re-enter.
If you input the wrong code three times in a row, the buzzer will beep for 60 seconds.
If no key is pressed for 20 seconds, the lock system will go to sleep, and the input will be cleared.
If you enter the wrong code three times, the buzzer will sound for 60 seconds continuously. If you still enter the wrong code three more times after the first 60 seconds, the buzzer will continue to sound for another 60 seconds continuously.
If both the red and green lights are on, this indicates that the batteries are depleted.
If you forget your code or if the batteries are depleted, you can use the emergency key to open the safe as you did during the initial opening. Then, press the reset button located on the back left side of the door to reset the code.
The “#” on the operation panel is the confirmation button, and the “” on the operation panel is the delete button. Pressing the “” key will clear all previous inputs.
If you press any key for 20 seconds and there is no subsequent input, the lock system will enter sleep mode and clear any input on the keypad.
If you happen to lose your emergency key, please locate the lock serial number on the lock hole and provide us with the relevant information when purchasing a replacement. We will provide you with a new key for an additional fee.