P S CG1638 Deluxe Cord Grip Instruction Manual
- June 15, 2024
- P S
Table of Contents
P S CG1638 Deluxe Cord Grip
Deluxe Cord Grip Assembly Instructions
- Cut cable square. Slide compression nut over cable.
- Compress mesh and slide over cable.
- Slide friction ring and grommet over cable.
- Secure the cord grip body to the enclosure.
- Slide the grommet into the body, and slide the friction ring and mesh to lay flat against the grommet. Note: The cable jacket may have to be stripped back to pass through the body.
- Tighten the compression nut onto the body. Remove all slack from the mesh by smoothing the mesh onto the cable.
Diagram Description
The image includes a diagram that shows the assembly of a Deluxe Cord Grip. The parts are labelled as follows:
- COMPRESSION NUT: A cylindrical component with external threading and a series of ridges on one end for grip.
- MESH: A flexible, braided sleeve that fits over the cable.
- CORD GRIP BODY: A cylindrical piece with internal threading on one end and a wider diameter on the other.
- FRICTION RING: A flat, annular component that sits between the mesh and the grommet.
- GROMMET: A cylindrical piece with a flange on one end and a hole in the centre to accommodate the cable.
The diagram also displays the cord grip assembly in an exploded view, showing the sequence of components as they fit together over the cable.
Specifications
| Part Number | 31-6472 REV A |
|---|---|
| Brand | Pass & Seymour / Legrand |
FAQ
- How do I prepare the cable for the Deluxe Cord Grip assembly?
- The cable should be cut square, and the cable jacket may need to be stripped back to pass through the cord grip body.
- What is the purpose of the friction ring in the assembly?
- The friction ring is used to ensure a secure fit between the mesh and the grommet, preventing movement and providing additional stability.
- Can I reuse the Deluxe Cord Grip components for another installation?
- Reusing components depends on their condition after removal. It’s important to assess each part for wear or damage before considering reuse.
- What should I do if there’s slack in the mesh after assembly?
- Any slack in the mesh should be removed by tightening the compression nut onto the body and smoothing the mesh onto the cable.
Installation Instructions
-
Cut cable square. Slide compression nut over cable.
Compress mesh and slide over cable. -
Slide friction ring and grommet over cable.
-
Secure the cord grip body to the enclosure.
-
Slide the grommet into the body, and slide the friction ring and mesh to lay flat against the grommet. Note: The cable jacket may have to be stripped back to pass through the body.
-
Tighten the compression nut onto the body. Remove all slack from the mesh by smoothing the mesh onto the cable.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>