NOKIA TWS852W Clarity Earbuds 2 Pro User Guide
- June 15, 2024
- Nokia
Table of Contents
- Get started
- Pair And Connect With Bluetooth®
- Touch Control
- Low Latency Mode (gaming & video mode)
- Sound Management
- Voice Pickup Microphone
- In-call Mode
- Reset To The Original Settings
- Accessories
- Declaration of Conformity
- FCC Notice to Users
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
NOKIA TWS852W Clarity Earbuds 2 Pro
Get started
Fully charge before use.
Pair And Connect With Bluetooth®
LED light of the earbuds will flash blue and red alternately.
Touch Control
Low Latency Mode (gaming & video mode)
Press control button (L) for 2 secs to toggle between low latency mode on/off.
Sound Management
Press control button (R) for 2 seconds to toggle between Hybrid ANC mode >
Ambient mode > OFF.
Voice Pickup Microphone
Voice will be picked up by the primary earbud. The earbud first taken out of the charging case will be the primary earbud.
In-call Mode
Light indicator will turn on while having a call conversation, so that people
around you will recognise you’re not to be disturbed.
Reset To The Original Settings
- Press charging case button for 10 secs.
- Battery status light will flash 3 times when earbuds are reseted.
- Earbuds LED will flash purple 3 times when earbuds are reseted.
Accessories
https://www.nokia.com/phones/support/user-guides
Nokia Clarity Earbuds 2 Pro (TWS-852W)
Declaration of Conformity
Hereby, HMD Global Oy declares that this product is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU.
A copy of the Declaration of Conformity can be found at:
www.nokia.com/mobile-declaration-of-conformity.
FCC Notice to Users
The following statement applies to all products that bear the FCC logo and/or
FCC ID on the product label.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC ID : 2AJOT-TWS852W
HMD Global Oy is the exclusive licensee of the Nokia brand for phones &
tablets.
Nokia is a registered trademark of Nokia Corporation. The Bluetooth word mark
and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use
of such marks by HMD Global is under license.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>