HANTECH HNT-MH-41 Universal PV Mounting System Instruction Manual
- June 15, 2024
- HANTECH
Table of Contents
HANTECH HNT-MH-41 Universal PV Mounting System Instruction Manual
Installation Steps
-
Place the rubber pads under the front and rear leg bases respectively, as shown in the following picture.
-
Install the L-shaped connector on the end of the adjustable rear leg outer expansion pipe, as shown in the following.
-
Install the adjustable front and rear legs on the photovoltaic panel, as shown in the picture above.
-
Fix the assembled universal bracket on the wooden floor or the metal sheet roof with tapping screw, as shown in the above picture.
Note: Turn the screw here to adjust the installation angle according to the local conditions. -
You can also fix the assembled universal bracket to the concrete floor or balcony wall with expansion bolts (Note: you need to purchase them according to the site conditions), as shown in the above.
| No. | Picture | Name | QTY |
|---|---|---|---|
| 01 | Adjustable front leg | 2 | |
| 02 | Adjustable rear leg | 2 | |
| 03 | L-shaped connector | 2 | |
| 04 | Rubber pad | 4 | |
| 05 | Tapping screw ST6.3*80 | 8 |
Hatch GmbH Daimlers. 6D-76185 Karlsruhe www.hantech.eu
