fatboy Edison the Petit White Table Lamp User Manual

June 4, 2024
fatboy

fatboy Edison the Petit White Table Lamp

Fatboy® product information Edison the Petit

The light source for the Fatboy® Edison the Petit is a dual LED module. The lamp is protected from dripping water. The lamp comes equipped with a Type-C USB connection. Please make sure to use a 5 V 1A adapter to charge the Edison the Petit. A fully charged lamp will remain lit for approximately 7,5/8 hours.

WARNING: READ CAREFULLY BEFORE USE!
SAVE THESE INSTRUCTIONS! THIS IS NOT A TOY, PLEASE KEEP AWAY FROM CHILDREN.

Instructions for use

  • Make sure you use a 5V 1A adapter (using a diff erent power adapter may cause irreparable damage to the luminaire).
  • Use only the supplied USB cable to charge the lamp.
  • Place the lamp on a dry, horizontal surface.
  • Do not expose the lamp to excessive heat from heat sources.
  • The lamp is intended for indoor use, but can be used outdoors without the cable/adapter. Protect it against water and store inside after use.
  • Check the voltage of your power supply. The voltage must be between 100 en 240 V AC current.
  • Charge the luminaire by inserting the USB Type-C plug into the slot (on the bottom of the luminaire).
  • Connect the recommended adapter and plug this 5V 1A adapter into the power outlet.

It will take approximately 3 hours to fully charge the lamp. We recommend charging the battery for 8 hours if you are charging it for the fi rst time. There is an indicator light located next to the Type-C USB slot. While the battery is charging, the red light will fl ash, and will remain lit when the battery is fully charged. Pull on the red Fatboy® tag to turn the lamp on. The brightness is adjustable by pulling label down, and hold it:

  • Starting position: the lamp is switched off ,
  • Pull the label once, the lamp turns on.
  • Pull and hold the label, the brightness will turn up and down (looping).
  • Release the label, it will fi x in position.
  • Pull the label shortly, the lamp will switch off .
  • Pull the label once again, the lamp turns on, it will remember it’s latest position.
  • Charge the lamp when it stops lighting up.

Battery

If the battery will not charge any more, please contact your Fatboy® dealer. Never try to replace the battery yourself. The disposal of batteries should be in compliance with any local regulations that address the disposal of hazardous materials. Do not incinerate!

Maintenance

  • When not in use for a long time, make sure the lamp is turned off .
  • We recommend to recharge the lamp every three months to keep the battery in good condition.
  • Do not leave the lamp outdoors for a long period.

Cleaning the lamp

  • Use a soft cloth, lukewarm water and liquid soft soap.
  • Do not use cleaning agents containing alcohol, ammonia, benzene, or abrasive substances.
  • Never open the lamp when cleaning.

Troubleshooting

  • The lamp has fallen and the shade has come loose:
    • Replace the shade on the lamp. If you hear a ‘click’ sound, the shade has been mounted correctly.
  • The lamp does not work:
    • Check the connection with the adapter.
  • The lamp has fallen and now is damaged:
    • If the lamp no longer works it is unsuitable for use. If this is the case, please contact your fatboy dealer.

Never attempt to repair the lamp yourself.
IMPORTANT!
Please contact your Fatboy® dealer if you have any other problems.

Technical specifications

  • Model: Edison the Petit
  • Secondary rating (charging): 5 V DC, 1000 mA (adapter not Included) Made in China
  • Safety Class: Class III
  • Connection: Type-C USB
  • Light source: 2x Cree® J Series (0,5W)
  • Switch: Built-in dimmer (Stepless dimming)
  • IP value: 21 (protected from dripping water)
  • Ambient temperature: -10 to 40°C
  • Materials: Polypropylene (lamp shade)
  • Internal battery: Li-PO 3.7V 1600 mA
  • Dimensions: 6.30 in/16 cm (diameter) x 9.84 in/25 cm (h)
  • Total weight product: 0.5 kg

This luminaire contains a LED light source, which cannot be replaced by the end user and shall only be replaced by the manufacturer or his service agent. When the light source reaches its end of life, the whole luminaire needs to be replaced. We do not recommend to use the lamp with the adapter connected for a long time, this can reduce the battery lifetime.
NOTE: THE LUMINAIRE SHALL BE CHARGED BY AN INDEPENDENT SELV LED DRIVER WHICH IS CERTIFIED WITH STANDARD EN 61347°2°13 ˛CLASS II, FAIL°SAFE OR SHORT CIRCUIT PROOF, WITH SUITABLE OUTPUT RATINGS, AND MAXIMUM OUTPUT VOLTAGE SHALL NOT EXCEED 5 VDC˝
PLEASE MAKE SURE TO USE A 5V, 1A CHARGER to prevent damage to your Edison the Petit

CE-directive
This product complies with the requirements and other relevant provisions of the current European RoHS and CE directives 2014/35/EC, 2014/30/EC and 2011/65/EC.

WEEE instruction

This product is subject to the provisions of the WEEE directive 2012/19/EU. Do not dispose this product together with regular household waste. Consult your local waste disposal authorities for information on collecting points for electrical and electronic waste products.

Guarantee terms

We thank you for purchasing this Fatboy® product and trust that you will enjoy using it. The local and applicable legislation on guarantee will apply to your purchase. Fatboy® cannot accept any claim on guarantee in the event of: Damage or defects caused by use; operation or treatment of the product in ways that are inconsistent with normal personal or domestic use; repairs or attempts to repair undertaken by any party other than Fatboy® the original B.V. Should you need to use our guarantee service, please contact your Fatboy® dealer. For more information about our dealers, please visit www.fatboy.com.

NOTE:
Changes or modifications which are not explicitly approved by the party responsible for compliance may void the user’s authorization to use the equipment.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals