EPSON 111-56-QUM-020 KDS True Order User Manual
- June 15, 2024
- Epson
Table of Contents
111-56-QUM-020 KDS True Order
111-56-QUM-020
Rev 3.00
User Manual
Updating Firmware
About this guide:
This guide consists of 2 sections:
- Overview – Where to identify the current KDS firmware version in an Epson TrueOrder Kitchen Display System (KDS).
- How to Update Firmware – Procedure to update the TrueOrder KDS firmware.
Overview
New releases of TrueOrder KDS firmware may have new features or fixes for any preexisting issues. However updating the firmware is only recommended if there is a good reason to do so. The firmware version of the device can be identified within the Configurator and it is also located on the KDS splash screen. The splash screen will be displayed during power up and will also be displayed by pressing the logo on header bar for a touch screen or pressing Summary key 3 times using a bump bar.
EPSON is a registered trademark and EPSON is a registered logomark of Seiko
Epson Corporation. All other product and brand names are trademarks and/or
registered trademarks of their respective companies. Epson disclaims any and
all rights in these marks.
Copyright 2023 Seiko Epson Corporation.
How to Update Firmware
This procedure needs to be followed for each device in your TrueOrder KDS system as each device is updated independently.
-
From a web browser access http://xxx.xxx.xxx.xxx/fwupdate.
Replace the xxx.xxx.xxx.xxx with the device IP. The device IP can be found on the KDS splash screen or referenced from the Configurator. The Updater webpage is protected by default login credentials (user: epson, password: epson).
The KDS Updater page will be displayed:
-
Click on “SELECT FILE”, browse to where you placed the firmware update ZIP file and select it, then click “Open”.
-
The firmware update ZIP file will be uploaded, wait until upload is done.
-
Wait until uploaded ZIP file is verified.
-
After ZIP file is successfully verified you will see “UPLOADING FILE DONE”. Click “CONTINUE”.
-
KDS Updater will install the new firmware and automaticallyrestart the application. You will see “INSTALLATION SUCCESSFUL!”. Click “DONE” to finish the firmware updating procedure.
-
Repeat all steps for each KDS device in your configuration to ensure they are all updated to the same firmware version.
Updating Firmware
Quick User Manual
111-56-QUM-020
Rev 3.00
Documents / Resources
|
EPSON 111-56-QUM-020 KDS True
Order
[pdf] User Manual
111-56-QUM-020 KDS True Order, 111-56-QUM-020, KDS True Order, True Order,
Order
---|---