TOOLSTATION 6kW EHC COMET Electric Boiler User Guide
- June 4, 2024
- TOOLSTATION
Table of Contents
6kW EHC COMET Electric Boiler
**User Guide
**
Comet Features
- 100% efficient
- Integrally sealed system kit
- Virtually silent in operation
- Suitable for central heating only or central heating & hot water
- Suitable for Underfloor Heating
- No Mandatory Maintenance required
- Stainless Steel Heat Exchanger
- 5 Year Warranty (T&C’s Apply)
- Volt-Free Control Connections
- 6 Stage Heating
- Integral System Diagnostics
- Easy-Fit Connectors & Sensors
- In-Built Fault Finding Diagnostics
- High Current Thermal Cut-Out
- Vortex Flow Temperature Sensor
- Digital Pressure Gauge
- ERP Smart Pump
- Removable bottom tray
Comet Overview
- Comet Electric System Boilers are designed to eliminate unnecessary external plumbing and pipe work. They are the ideal choice for wet central heating and underfloor heating systems.
- Our single phase Electric System Boiler outputs are 6kW, 9kW, and 12kW with the 14.4kW available for properties that require larger outputs.
- To ensure maximum efficiency, all our Comet Boilers are fully modulating. This unique facility will enable the Boiler to reduce electricity consumption and running costs.
- The operating temperature of the Boiler can be adjusted from 20 degrees through to a maximum of 85 degrees.
- In larger homes or light commercial properties with a 3-Phase electricity supply, we supply 12kW, 14,4kW, 23kW, 39kW, and 48kW output Boilers.
- For multiple Boiler installations, it is also possible to install them in series in a low-loss header configuration for properties with higher heat demands.
- Please allow an addition of 3kW or 10000BTU’s if coupling with an Indirect cylinder.
SPECIFICATIONS
Height: 710mm Width: 418mm Depth: 251mm Weight: 25kg
| Boiler Range | kW | 6kW | 9kW | 12kW | 14.4kW |
|---|---|---|---|---|---|
| Pipe Entry from Boilers | Bottom Entry | Bottom Entry | |||
| Flow & Return Pipes | mm | 22 | |||
| Min/Max Water Pressure | Bar | 0.5/3.0 | |||
| Expansion Vessel | Ltrs | 6.0 | |||
| Dry Weight | Kgs | 25 | |||
| Electricity Supply | VAC | 240V 1ph 50Hz | |||
| Load Current | Amp | 25 | 38 | 50 | 60 |
| Heating Output | Btu’s per/kW | 20472 | 30709 | 40945 | 49134 |
| Min/Max Temp Settings | °C | 20/85 | |||
| Overheat Protection | °C | 100 | |||
| Pump Included | Yes |
Recommended
Pump Settings| | | | Factory Set to Max (adjustable)|
Recommended
Diameter of Mains Cable| mm| 6| 10| 16| 16
Protection| Amp| 32| 50| 63| 80
IP Rating| | D| D| D| D
INSTALLATION
Heating Only Design
Heating Only with Direct Cylinder Hot Water Design
Heating and Hot Water Design with Indirect Cylinder
Heating and Hot Water Design with Pre-Plumbed Indirect Cylinder
01698 820533
https://www.electric-heatingcompany.co.uk/electric-boilers/comet/
info@electric-heatingcompany.co.uk
Block 5, Unit 40, Third Road
Blantyre Industrial Estate
Blantyre, South Lanarkshire G72 0UP
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>