DESSALATOR Ac Pro Compact and Cad User Guide
- June 15, 2024
- DESSALATOR
Table of Contents
DESSALATOR Ac Pro Compact and Cad
START-UP PROCEDURE
- Make sure the hull valve for the watermaker is opened, the selection valve on the pre-pump is in the sea water position and turn the pressure regulator knob almost fully counter clockwise (towards the (-) position).
- Set the switch to MANUAL.
- Press the START Button. The pre-pump will start, wait until only the YELLOW LED blinks.
- Slightly increase the pressure up to 8 o’clock on the pressure gauge using the regulator knob. Stay in this position for about two minutes.
- Increase the pressure to 11 o’clock using the regulator knob. Stay in this position for about one minute.
- Now you can increase the pressure to the green zone on the pressure gauge. When the water quality LED lights up green, your water maker produces fresh water.
ALARM
POOR QUALITY
GOOD QUALITY
SHUTDOWN PROCEDURE
- Set the power switch to OFF, to stop the water maker.
- Turn the knob pressure regulator almost fully counter clockwise (towards the (-) position).
his Quick Guide is intended only as a reminder for everyday use. Make sure you are familiar with the contents of the full manual before using your water maker. See www.dessalator.com or flash this QR code.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>