Tianqi T025 Remote Control Cabinet Light User Manual
- June 15, 2024
- Tianqi
Table of Contents
T025 Remote Control Cabinet Light
User Manual
PACKAGE CONTENTS
SAFETY INFORMATION
Please read and understand this entire manual before attemting to assemble, operate or install the product. Anywhere Nightlight, Wall Light for Entrance, Hallway, Basement , Cabinet, Closet and so on.
ASSEMBLY INSTRUCTIONS
- Determine and lightly mark location for each puck.
- To open the puck, rotate the two halves until the parts are aligned, then lift off the top.
- Install batteries, matching polarity, into each puck.
- Reassemble the puck by aligning the covers then rotating to secure.
- Attach one adhesive mounting pad to the underside of each puck light.
- Peel off adhesive strip and push puck firmly to secure to mounting surface in locations marked.
- By pressing the lamp body center, you can turn off the lamp manually, turn on the lamp and adjust the color of the lamp.
- To replace remote control´s battery follow directions on back of remote control to slide battery drawer out. Replace battery(+side up) and slide battery drawer back in.
- Use remote control for on/off control, dimming and setting operation duration. You can put it in the bathroom, wardrobe, cabinet, bed side cabinet corridor, etc. It’s more convenient for lighting at night.
SAFETY INFORMATION
Before beginning installation of product, make sure all parts are present.
Compare parts with package contents list and hardware contents list. If any
part is missing or damaged, do not attempt to assemble, install or operate the
product.
FCC Warnning:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, macaques harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipmentoff and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>