EMPHASER EM-MBSUBL2 Anleitung Car Audio Sound System User Manual

June 15, 2024
EMPHASER

EMPHASER logo EM-MBSUBL2 Anleitung Car Audio Sound System
User Manual

EM-MBSUBL2 Anleitung Car Audio Sound System

UNIVERSE
EM-MBSUBR2

Congratulations!
On your purchase of the EM PHASER subwoofer system dedicated for Mercedes-Benz vehicles. If you plan on installing this speaker system by yourself, please read the following instructions carefully before you attempt the installation.
For any further information about this product, please contact your authorized EM PHASER dealer.

SET CONTENT

Carefully remove the loudspeakers, crossovers and the accessories from the gift box and check whether all parts are in good undamaged condition, and match with the set contents listed below:

  • 1 subwoofer
  • 1 lowpass crossover
  • 1 manual

ASSEMBLY

This set is compatible with a variety of Mercedes-Benz vehicles. For step by step instructions on how to disassemble the original loudspeakers of your specific vehicle correctly, please contact your Mercedes-Benz service workshop. The  following instructions for the C205 model are to serve as an example for all models.
Carefully pull the sill cover up; it is just plugged. Start from the side of the B-pillar and work your way forward.
Remove the cover under the glove compartment. It is fixed in the front area with two screws and in the rear with some clips. Finally, disconnect the cables from this cover.
In this model the carpet ends just in front of the seats. Pull the carpet out this side first, then pull it up and out the door. EMPHASER EM MBSUBL2
Anleitung Car Audio Sound System

Remove the footrest by loosening the nuts (rectangle).
Remove the three screws marked with a circle to facilitate access to the original subwoofer. EMPHASER EM MBSUBL2 Anleitung Car Audio Sound System -
figFinally, loosen the three screws of the woofer. To unlock the speaker connector, use a small flat-head screwdriver or a paper clip.
Remove the rear part including insulation wool from the original woofer and mount it at the same place on the EM PHASER subwoofer.
Install the EM PHASER speaker in the vehicle. Plug in the low-pass crossover supplied with the set and store it underneath the woofer. If necessary, wrap the switch in a cloth or fix it firmly to prevent rattling noises.
Assemble the vehicle in reverse order.

WARRANTY CONDITIONS + LIMITATIONS

What products are covered by EMPHASER’s limited Warranty?
The limited Warranty (the “Warranty”) applies to EM PHASER products purchased from an authorized dealer by end customers in the European Economic Area or Switzerland (“Territorial Scope”).
What is the validity period of EMPHASER’s Warranty?
Under this Warranty, EM PHASER warrants, for a period of 2 years, that the product is free from defects in material and/or workmanship at the time of the original purchase. This 2-year period commences on the date of the original purchase as per the original invoice or until receipt. If you have purchased the product as a consumer, and the defect is identified within the first six months after the original purchase (see above), we will assume that the defect already existed at the time of purchase.
Who can claim under the Warranty?
EM PHASER grants the limited Warranty to natural persons only, who purchased the relevant product primarily for personal use.
What is covered by the Warranty?
EM PHASER warrants that the product is free from defects in material and/or workmanship at the time of the original purchase. EM PHASER does not, however, provide a warranty covering every defect and damage that may occur. It  only covers the hardware components of the device, and in no event the software used with the device, regardless if this was provided by EM PHASER or the third-party vendor. The Warranty therefore does not cover the following cases, in particular:

  • normal wear and tear (such as to surfaces and protective coverings);
  • superficial damage, such as scratches, dents, and damaged plastic, worn or mechanically defective connections;
  • misuse, including any treatment resulting in physical or superficial damage, such as a cosmetic defect, to the product;
  • damage caused by connecting or using the product for a purpose other than those specified, or a failure to observe the operating and/or installation instructions for the particular model;
  • installation or use of the product contrary to the applicable technical standards, or the safety regulations in the country in which the product is installed or used;
  • damage caused through an unauthorized attempted repair, or an attempted repair by someone other than a EM PHASER authorized service partner;
  • damage caused by modifications to the product not expressly authorized by the manufacturer;
  • damage caused by malicious code (“Software Viruses”) or by using software not supplied with the product or which was incorrectly installed;
  • use of third party vendor software programs for editing, modifying, adapting, or extending EMPHASER’s authorized software components as are run on the product;
  • use of third-party vendor firmware/operating system software
  • damage caused by liquids or chemicals of whatever type, and/or excessive temperatures, moisture, or damp;
  • accidents, drops or other such effects of extreme accelerating forces;
  • damage caused by lightning strikes, electrostatic charge, incorrect operating voltage, water, fire, force majeure, inadequate ventilation for other reasons for which EM PHASER is not responsible;
  • damage caused by using the device outside of the defined specifications;
  • damage caused by using the product with other systems or devices, which are not designed to be used with this product;
  • adjustments or modifications without EMPHASER’s prior written approval, including product upgrades extending beyond the specifications or characteristics described in the operating manual;
  • modifications of the product for the purpose of adapting it to national or local technical norms or safety standards of countries for which the product was not expressly designed or manufactured;
  • using service or spare parts not produced or distributed by EM PHASER;
  • using the product in connection with accessories not approved for use with this product;

EM PHASER , moreover, does not warrant (expressly, implicitly, statutorily, or otherwise) the quality, performance, reliability or suitability of the product for a particular purpose except as described, nor the software/firmware installed on the device ex works.
No warranty service will be provided, moreover, if the model number /serial number/UUID/product number on the product is changed, erased, made illegible or removed. The same applies if the receipt or invoice is incomplete and/or illegible when presented.
Is EM PHASER liable for other defects or damage?
EM PHASER will repair or replace products, only if they are covered by the terms of this Warranty. EM PHASER is not liable for any material or intangible loss or damage such as the price paid for the product, loss of profits, revenue,  data, or relating to the enjoyment of the product or components associated with it, arising directly or indirectly under this Warranty or otherwise in relation to products or services. This likewise applies to loss or damage relating to the  impairment or operational failure of the product, or devices associated with it, caused by defects or the non-availability of the product during the time it is with EM PHASER or EMPHASER’s service partner, as well as to periods of  downtime and business interruptions. In addition, EM PHASER does not accept any liability for shipment-related risks – such as the loss or destruction of the product- in connection with the fulfilment of the Warranty.
This disclaimer applies to losses of damage irrespective of the legal basis, especially on the grounds of negligence, other wrongful conduct (torts), breach of contract, express or implied guarantees, and strict liability (even if EM PHASER  or its service partner has been advised of the possibility of such damage occurring).
If these disclaimers are prohibited or limited under the applicable law, EM PHASER will limit its Warranty and liability to the extent permissible under the applicable regulations. For example, some national laws prohibit the exclusion or  limiting of damages payable in connection with negligence, gross negligence, willful wrongdoing, deceitful conduct, and other such acts. For the duration of this Warranty, all liability that cannot be excluded completely will be limited  to the extent permissible under the applicable law. Liability under this Warranty is limited to the price paid for the product. If the applicable law only permits higher limits on any liability, this higher limitation will apply.
How do I exercise my Warranty rights?
If you want to exercise your entitlements under this Warranty, please contact the authorized dealer where the product was purchased, and present it with the original copy of the till receipt or invoice. Do not return any products to EM PHASER directly, otherwise our Warranty obligations cannot be fulfilled. You will find the name of the relevant dealer or reseller on your proof of purchase.
Defective devices sent by the authorized dealer to the service center, must also be accompanied by any accessories with a logical connection to the observed fault. This means, for example, the navigation package on an SD or microSD card  supplied or purchased with the device, if problems or functional errors were observed in connection with the navigation function.
How will EMPHASER fulfil its Warranty?
EM PHASER or its service partner will choose to either repair or replace the product or its defective parts covered by the Warranty, and assume the costs of material and labor in doing so.
Repairs under the Warranty must be carried out by EM PHASER or its authorized service partner. Products that are repaired or replaced may contain new and/or refurbished components and devices. Components that are swapped out  will become the property of EM PHASER.
Will I incur any costs in connection with the Warranty service?
EM PHASER assumes the costs of material and labor in connection with its Warranty service. The Warranty holder is responsible for the costs of shipment and bears the risks connected with the shipment (see above). If the product is found to be operating faultlessly, or there is no warranty entitlement because the warrant period has expired or for any other reason, EM PHASER or its authorized service partner will be entitled to charge a flat-rate investigation fee of €30.00.
Do this Warranty affect my statutory or contractual rights?
This Warranty is made voluntarily by EM PHASER, and it will, in any case, extend your statutory rights. As a consumer, you remain fully entitled to your statutory rights, such as the statutory guarantee. This Warranty also has no effect  whatsoever on your contractual rights against the reseller. You may continue to exercise these rights in full.

WARRANTY CARD

MODEL: [J EM-MBSUBR2
Date of purchase:———–
Your name:——————-
Your address:—————-
City:—————————
State:————————–
ZIP or Postal Code:———-
Country:————————
Your phone number:——–

Dealer’s address & stamp| Installation Approval
0 Installed by
authorized dealer
J self-installed
by customer
Installation date:
Inspected and
approved by:
---|---

VEHICLE COMPATIBILITY LIST
You can find a detailed list on www.emphaser.com

EMPHASER
Manufacturer:
ACR, Brandlin + Vogel AG, Bohrturmweg 1,
CH-5330 Bad Zorach, Switzerland
Phone: (+41) (0)56 269 64 64,
Fax:(+41) (0)56 269 64 65,mail@acr.eu,www.acr.eu
EU Legal Representative: ACR S & V GmbH,
Industriestra~e 35, D-79787 Lauchringen, Germany
Designed and Engineered in Switzerland.
Made in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals